Operating Instructions Dishwasher G 5500 G 5505 G 5510 G 5515 en - US, CA To prevent accidents and appliance damage read these instructions before installation or use. M.-Nr. 09 016 330...
If the supplied power cord is damaged it must only be replaced by a Miele Service technician with a genuine Miele power cord. The outlet must be accessible at all times after installation to disconnect the...
Page 5
The dishwasher must be installed and connected in accordance with the installation instructions. Installation and repair work should be performed by a Miele authorized service technician. Work by unqualified persons could be dangerous and may void the warranty. Do not install or use a damaged dishwasher.
Page 6
It is possible for small fingers may be pinched in the door. Only use the dishwasher if all panels are properly in place. Do not tamper with the controls. Do not sit or stand on the door or baskets of the dishwasher.
Cutlery tray Upper basket Middle spray arm Air inlet for drying (depending on model) Lower spray arm Guide to the dishwasher Triple filter system Data plate Child Safety Lock in the door handle (not visible) Rinse aid reservoir Dual compartment detergent...
Start / Stop button with indicator light Delay Start button with indicator light Turbo button with indicator light This operating instruction manual describes several dishwasher models with different indicated settings. The different dishwasher models are named : Standard = 32 "...
For best results follow these tips: ^ For lowest energy consumption you may connect the dishwasher to a cold water source. ^ For fastest possible wash times, with slightly higher energy consumption, connect the dishwasher to a hot water source.
To open the door ^ Reach under the handle and pull the door open. If the door is opened during operation the dishwasher will stop running. Once the door is closed the program will restart. To close the door ^ Push the baskets in.
To show the display again, press any button. Before using for the first time Settings menu You can adjust the dishwasher's electronics to suit various requirements in the Settings menu. See the"Settings" section of this manual for more information.
Page 12
Before using for the first time ^ Press the K button to turn the dishwasher on. A Welcome screen shows when the dishwasher is turned on for the first time. Language The display changes automatically to the language setting. ^ Select the desired language and confirm with the center button.
Filling the salt container To achieve good cleaning results, the dishwasher needs soft water (water that is low in minerals). Hard water results in calcium deposits on dishware and in the dishwasher. Therefore, if your tap water hardness is above 4 °d (4 gr/gal) the water should...
The Insufficient salt message is turned off if you have programmed the dishwasher to a water hardness below 4 °d (4 gr/gal). If using"Tab" detergent products in your dishwasher, the messages can be turned off if desired (see "Settings - Deactivate indicators").
Rinse aid Rinse aid helps to prevent spotting on dishes and glassware. The rinse aid is filled in the reservoir and the set amount will be automatically dosed. Filling the rinse aid reservoir with detergent (liquid or powder) will damage the reservoir. Only pour rinse aid formulated for residential dishwashers into the reservoir.
^ Confirm with the center button. The "Refill rinse aid" message will go out. If using "Tab" detergent products in your dishwasher, the messages can be turned off if desired (see "Settings - Deactivate indicators"). If you switch to using detergent that...
Wax, grease and paint will cause permanent discoloration and damage to the dishwasher. ^ Scrape food from dishes before placing them in the dishwasher, rinsing is not necessary. ^ Some foods contain natural dyes, e.g. carrots or tomatoes. Plastic items may discolor permanently if they come in contact with food dyes.
The China & Crystal program*, although extremely gentle and thorough can cause the china and crystal to "wear" if they are not dishwasher safe. Glassware: – There are no standard guidelines for washing glassware, when in doubt wash by hand.
Upper basket Always use the dishwasher with the upper and lower basket inserted Tall items (except during the program, if available). ^ Load the upper basket with small, lightweight, or delicate items such as cups, saucers, glasses, dessert bowls, etc.
Page 22
Loading the dishwasher Jumbo cup rack (depending on model): The cup rack can be set at two different widths so that it can also accommodate large cups. ^ Pull the cup rack upwards and click it back into position at the required width.
Page 23
^ Pull the support bar upwards and click it back into position at the required height. Use the low setting for small glasses and tumblers. Use the high setting for tall glasses and stem ware. Loading the dishwasher...
Page 24
Loading the dishwasher Adjusting the upper basket In order to gain more space for taller items the upper basket can be adjusted on three levels with 2 cm between each level. The upper basket can also be set at an angle with one side high and the other side low.
Glasses, cups, small plates and saucers can also be arranged in the lower basket. Dishwasher with cutlery tray Dishwasher with cutlery basket Loading the dishwasher Heavily soiled items ^ Place large platters and dishes in the center of the lower basket.
Page 26
Loading the dishwasher Removable MultiComfort insert The rear section of the lower basket is used for cups, glasses, plates, pots and pans. You can remove the MultiComfort insert to provide more space for larger items such as pots and pans.
Page 27
Loading the dishwasher Foldable spikes (depending on model) The spikes at the front are used for plates, soup bowls, platters, desert bowls, and saucers. Both rows of spikes can be folded down to create more room for larger dishware, e. g. pots, pans and bowls.
Loading the dishwasher Cutlery Split cutlery tray (depending on model) ^ Arrange the cutlery as shown in the cutlery tray. For easier unloading cutlery should be grouped in zones, one for knives, one for forks, one for spoons, etc. Spoon heads should be placed in...
^ Place small items of cutlery in the individual slots on three sides of the cutlery basket. Loading the dishwasher Cutlery insert for the cutlery basket Use the insert supplied for heavily soiled items of cutlery. The insert separates the items so that they can be reached better by the spray jets.
...wash long-stemmed glassware MieleCare Collection Miele branded cleaning and care products, including dishwasher salt, detergent and rinse aid, are available to order from your Miele dealer, Miele or the on-line Miele store www.mieleusa.com the following accessory will need to be ordered...
If using a Tab detergent see "Settings - Deactivate indicators". Detergent tabs are not recommended for use with the program "Express" (depending on model). The tabs may not dissolve completely. Dishwasher cleaning products are available from MIele.
Adding detergent ^ Press the latch on the detergent dispenser. The flap will spring open. The flap is always open at the end of a program. ^ Add detergent to the compartments and close the container flap. ^ Use one tab or add powder or gel detergent to compartment II and close the flap.
^ Close the door. ^ Open the water supply, if it is closed. ^ Press the K button to turn the dishwasher on. The last program selected will appear in the display and the appropriate indicator light will come on.
Program Guide Program When to use Pots & Pans For normally soiled pots & pans with dried on food, and heavily soiled dishware, use 120% detergent recommended. Normal Program for completely washing a full load of normally soiled dishware with the ability to adjust energy and water consumption based on the soil load of the dishware.
Start/Stop indicator light flashes slowly. ^ To turn the dishwasher back on press If the dishwasher is not turned off after the program ends, it will turn completely off after a few minutes in standby mode (see "Settings - Optimize...
To be completely safe, you must turn off the water supply to each individual appliance. This means under the sink for a dishwasher, at the laundry bib for your washer, etc.
If the door is closed again, the program will continue from where it was interrupted. Water in the dishwasher is hot. Danger of scalding. Only open the door if absolutely necessary and exercise extreme caution when doing so. Before closing the door again, leave it ajar for approx.
Depending on the program, this can mean that the running time varies slightly. ^ Press the K button to turn the dishwasher on. The "Start / Stop" indicator light flashes. ^ Select a program. ^ Press the "Intensive lower basket"...
Do not use liquid detergent. The detergent could leak out of the compartment. ^ Press the K button to turn the dishwasher on. The "Start / Stop" indicator light flashes. ^ Select the desired program with the "Program" button. ^ Press the "Delay start" button.
^ Press and hold the "Start / Stop" button. ^ Turn the dishwasher on with the K button and hold the "Start / Stop" button down for a few seconds. The first option of the Settings menu will appear in the display and all the indicator lights will come on.
Water hardness Your dishwasher is fitted with a water softener that needs to be programmed to the water hardness level in your area. – The dishwasher must be correctly programmed to match the hardness of your water. – Your local water authority will be able to advise you of the exact water hardness level in your area.
The display and the indicators are turned off and only the Start/Stop indicator light flashes slowly. If the dishwasher is not turned off after the program ends, it will turn completely off after a few minutes in Standby mode.
Refill indicators If you consistently use "Tab" detergent products in your dishwasher, you can switch the Salt and Rinse Aid indicators off if desired. ^ Select the desired setting and confirm with the center button. If you switch to using a detergent...
50 cycles. ^ Select the desired interval and confirm with the center button. Showroom program Only for showrooms. The dishwasher has a demo program for dealer's showrooms. Demo with wash sound – The program activates the pumps to demonstrate the wash sound.
– Reset the circuit breaker. See the data plate for minimum amperage. – If the circuit breaker trips again. Contact Miele. Before fixing the fault: – Press the K button to turn the dishwasher off. After a few seconds: –...
There might be water in the wash cabinet. Solution Before fixing the fault: – Press the K button to turn the dishwasher off. Open the water supply valve all the way. Before fixing the fault: – Press the K button to turn the dishwasher off.
General problems with the dishwasher Problem The indicators and the display is dark. Only the "Start/Stop" indicator flashes slowly. Detergent residue is left in the dispenser at the end of a program. The detergent dispenser lid cannot be closed properly.
Interrupt the program, and rearrange loose pieces. Remove the foreign object from the drain pump (see "Cleaning the drain pump and non-return valve") This has no effect on the dishwasher. If in doubt, contact a plumber.
Wash water will run back into the wash cabinet. The rinse aid dosage is set too high. Solution See "Loading the dishwasher". Select a more intensive program (see "Program Guide"). Use the function "Adjust Sensor Wash" (depending on model, see "Settings").
Page 50
Frequently Asked Questions Problem Possible fault Dishes are not dry, The rinse aid setting may be glasses and too low, or the rinse aid cutlery are reservoir is empty. spotted. Dishes were taken out too soon. A "Tab" product was used. These products have a low drying effect.
Page 51
Plastics are discolored. There are rust stains on cutlery. Frequently Asked Questions Possible fault Detergent deposits. Glasses are not dishwasher safe. The surface is affected. The wash temperature of the selected program was too low. The detergent has a low bleaching effect.
Miele’s Service department, Extended Service Contracts offered by other providers for Miele products will not be recognized by Miele. Our goal is to prevent unauthorized (and untrained) service personnel from working on your Miele products, possibly doing further damage to them, you and/or your home.
To transport the dishwasher, e.g. when moving to a new home, note the following: – Empty the dishwasher. – Secure any loose parts, e.g. hoses, cables, cutlery baskets. – Transport the dishwasher in the upright position. If unavoidable it may be transported on its back. Do not transport it on its side or on the door.
The wash cabinet can be cleaned with a dishwasher cleaner such as "Dis Cleaner" available from your Miele dealer or online at www.mieleusa.com. Door and the door seal ^ Wipe the door seals regularly with a damp cloth to remove food deposits.
The dishwasher must not be used without all the filters in place. Collection of coarse dirt may cause the filters to clog. The level of soiling and...
Page 58
Cleaning and Care To clean the inside of the filter, the flap must be opened: ^ Push the clips together in the direction of the arrows as shown, and open the flap ^ Rinse all parts under running water. ^ Close the flap so that the clip engages.
Sometimes particles of food get stuck in the spray arm jets. The spray arms should be inspected and cleaned every 4 - 6 months. ^ Turn off the dishwasher before cleaning. Removing the spray arms ^ Remove the cutlery tray (if present).
If the dishwasher is not completely drained at the end of a program, the drain pump or non-return valve may be blocked. ^ Turn off the dishwasher and pull the plug. ^ Remove the triple filter (see "Triple filter system").
Installation Instructions Please refer to the Installation Diagram supplied with these instructions. To comply with IEC sound testing protocols, please contact Miele for additional instructions. Information is subject to change. Please refer to our website to obtain the most current product specification, technical & warranty information.
Help to protect the environment Disposal of the packing material The cardboard box and packaging protect the appliance during shipping. These materials are biodegradable and recyclable. Please recycle. Ensure that any plastic wrappings, bags etc. are disposed of safely and kept out of the reach of children.
Danger of overheating! See data plate on the right side of the door. A damaged power cord must only be replaced with a genuine Miele cord by a Miele service technician. GROUNDING INSTRUCTIONS THIS APPLIANCE MUST BE GROUNDED.
Page 64
Electrical connection Hardwired electrical connection It is possible to hardwire this appliance to an existing power cable. CAUTION: Before servicing, disconnect the power supply by either removing the fuse, shutting off the power main or manually "tripping" the circuit breaker. Installation work and repairs should only be performed by a qualified technician in accordance with all...
Do not drink water from the dishwasher! – The dishwasher can heat its own water to the temperature required by the wash program. This allows for connection of the machine to either a hot (max. 140°F / 60°C) or cold water source.
5 ft (1.5 m) flexible drain hose with an internal diameter of 7/8" (22 mm). – Drain hose extensions and adapters can be ordered from Miele. The maximum drain hose length is 13 ft. (4 m), max. drain height: 39"...
Page 68
Alteration rights reserved / 4711 M.-Nr. 09 016 330 / 03 G5500/G5505/G5510/G5515 / INFORMATION IS SUBJECT TO CHANGE. PLEASE REFER TO OUR WEBSITE TO OBTAIN THE MOST CURRENT PRODUCT SPECIFICATIONS, TECHNICAL & WARRANTY INFORMATION.