13. TECHNICAL INFORMATION................18 WE’RE THINKING OF YOU Thank you for purchasing an Electrolux appliance. You’ve chosen a product that brings with it decades of professional experience and innovation. Ingenious and stylish, it has been designed with you in mind. So whenever you use it, you can be safe in the knowledge that you’ll get great results every time.
Page 3
ENGLISH responsible if an incorrect installation and use causes injuries and damages. Always keep the instructions with the appliance for future reference. 1.1 Children and vulnerable people safety This appliance can be used by children aged from 8 • years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe...
Before maintenance, deactivate the appliance and • disconnect the mains plug from the mains socket. Do not use water spray and steam to clean the • appliance. The ventilation openings in the base (if applicable) must • not be obstructed by a carpet.
ENGLISH 2.5 Service damaged, the water in the hose becomes dark. • Contact the Authorised Service Centre • If the water inlet hose is damaged, to repair the appliance. We immediately disconnect the mains plug recommend only the use of original from the mains socket.
Water Energy Duration Programme (kWh) (min) 1) The pressure and the temperature of the water, the variations of the mains supply, the op- tions and the quantity of dishes can change the values. 5.2 Information for test institutes Write down the product number (PNC) that is on the rating plate.
– = rinse aid dispenser – = Acoustic signal off. deactivated. – = Acoustic signal on. 3. Press Option to change the setting. 3. Press Delay to change the setting. 4. Press the on/off button to confirm the 4. Press the on/off button to confirm the setting.
ENGLISH This option deactivates the release of salt. also the energy consumption The salt indicator does not come on. (approximately -25%). With the use of this option the programme Dishes can still be wet once the duration is prolonged to increase the programme is completed.
Water and salt can come out CAUTION! from the salt container when Only use rinse aid specifically you fill it. Risk of corrosion. To designed for dishwashers. prevent it, after you fill the salt 1. Press the release button (D) to open container, start a programme.
ENGLISH 4. Set the applicable options. 5. Press Start to start the programme. • The washing phase indicator comes on . • The programme duration starts to decrease with steps of 1 minute. Starting a programme with delay start 1. Set a programme. 2.
Make sure that there is detergent in the All buttons are inactive except for the detergent dispenser before you start a on/off button. new programme. 1. Press the on/off button or wait for the Auto Off function to automatically End of the programme deactivate the appliance.
ENGLISH 10.4 Loading the baskets • The filters are clean and correctly installed. • Only use the appliance to wash items • The cap of the salt container is tight. that are dishwasher-safe. • The spray arms are not clogged. •...
7. Reassemble the filters (B) and (C). 8. Put back the filter (B) in the flat filter (A). Turn it clockwise until it locks. 2. Remove the filter (C) out of filter (B). 3. Remove the flat filter (A).
ENGLISH • If you regularly use short duration recommend to run long duration programmes, these can leave deposits programmes at least 2 times per of grease and limescale inside the month. appliance. To prevent this, we 12. TROUBLESHOOTING If the appliance does not start or it stops With some problems, the display during operation.
12.1 The washing and drying results are not satisfactory Problem Possible solution There are whitish streaks or • The release quantity of rinse aid is too much. Adjust bluish layers on glasses and the rinse aid selector to a lower position.