Setting The Cross-Subsystem Paths - HP StorageWorks XP24000 User Manual
External storage
Hide thumbs
Also See for StorageWorks XP24000:
- User manual (117 pages) ,
- Configuration manual (58 pages) ,
- Reference manual (456 pages)
Table of Contents
Advertisement
5.
Make the settings to all the LDEVs in the LDKC:CU:LDEV column (repeat step
4).
6.
Click OK.
The specified numbers are assigned to the LDEVs. However, the Add Volume dialog box shows
only the LDEV number assigned for the first LDEV of each external volume.
Figure 30 Example of LDEV Mapping (Manual) Dialog Box
You can also assign contiguous LDEV numbers to LDEVs using this dialog box. To assign contiguous
LDEV numbers to LDEVs, select multiple LDEVs at step 2, and specify the starting LDEV number at
step
3
and 4. You can set Interval if necessary.
Setting the Cross-subsystem Paths
You need to configure the cross-subsystem path from the internal volume to the external volume
before using the external volume mapped as an internal volume. For details on the cross-subsystem
path, see
"Cross-subsystem Paths" (page
You can configure the cross-subsystem path when you map the external volume as the internal
volume. You can also add or change the cross-subsystem paths after the mapping operation is
completed. To configure the cross-subsystem paths, use the Configure Cross-subsystem Paths dialog
box.
CAUTION:
cross-subsystem paths for them in one operation. To replace all the current cross-subsystem paths
with newly added cross-subsystem paths, you need to perform more than two operations and leave
at least one current cross-subsystem path setting when you perform the first operation.
74
Performing XP External Storage Operations
You cannot delete all the current cross-subsystem paths to substitute newly added
17).
2
through step
HP Confidential
Advertisement
Table of Contents
Troubleshooting
