A local telephone company may make changes in its communications facilities or procedure. If these changes could reasonably be expected to affect the use of the GT350 or compatibility with the network, the telephone company is required to give advanced written notice to the user, allowing the user to take appropriate steps to maintain telephone service.
Page 22
3. TECHNICAL BRIEF 3.2.7 GPIO map Over a hundred allowable resources, GT350 is using as follows except dedicated to SIM and Memory. GPIO(General Purpose Input/Output) Map, describing application is shown in below table Table 5 S-Gold3 GPIO pin Map Port function...
Vbat-0.3) the above-mentioned bit won’t be set. To support Remote power on function for factory mass production, applied an analog switch as following figure. As monitoring the F_MODE and Key matrix KEY_ROW5& KEY_COL7, GT350 system recognize whether remote power on or End-key pushed.
3. TECHNICAL BRIEF 3.5 SIM & uSD interface GT350 supports 1.8V & 2.9V plug in SIM, SIM interface scheme is shown in (Figure 8). SIM_IO, SIM_CLK, SIM_RST ports are used to communicate with BBP(S-Gold3) and the SIM power supply enabled by PMIC.
3. TECHNICAL BRIEF 3.6 Memory 2Gbit NAND & 1Gbit DDR SDRAM employed on GT350 with 8 & 16 bit parallel data bus thru DDR_A[0:13] and DDR_DQ[0:15]. The 2Gbit Nand Flash memory with DDR RAM stacked device family offers multiple high-performance solutions.