Page 20
PA MODE PAM Mode select 3.2.5. USIF Interface GS290 have three USIF Drivers as follow : - USIF1 : Hardware Flow Control / SW upgrade / Calibration - USIF2 : Not used Rx, Tx and CTS, RTS use BT Interface...
Page 22
3.2.7. GPIO map 3.2.7. GPIO map Over a hundred allowable resources, GS290 is using as follows except dedicated to SIM and Memory. GS290 GPIO(General Purpose Input/Output) Map, describing application, I/O state, and enable level, is shown in below Over a hundred allowable resources, GS290 is using as follows except dedicated to SIM and Memory. GS290...
Vbat-0.3) the above-mentioned bit won’t be set. To support Remote power on function for factory mass production, applied an analog switch as following figure. As monitoring the RPWRON and Key matrix KP_OUT(2) & KP_IN (6), GS290 system recognize whether remote power on or End-key pushed...
Page 36
Figure 7 Remote power on and End-key power on circuit 3.5. SIM & uSD interface GS290 supports 1.8V & 2.9V plug in SIM, SIM interface scheme is shown in (Figure 8). SIM_IO, SIM_CLK, SIM_RST ports are used to communicate with BBP(S-Gold3) and the SIM power supply enabled by PMIC.
GS290 Operational Description Revision B 3.6. Memory 2Gbit NAND & 1Gbit DDRSDRAM employed on GS290 with 8 & 16 bit parallel data bus thru ADD(0) ~ ADD(29). 3.6. Memory The 512Mbit Nand Flash memory with DDRAM stacked device family offers multiple high-performance solutions.