C H A P T E R Overview This chapter provides an overview of the Cisco UCS C3160 high-density storage server. Front Panel Features Figure 1-1 shows the front panel features of the system. The system is shown with the removable front bezel installed.
System I/O controller (SIOC), one or two. 16 Do not use this SIOC 2 port. Use the Port types vary, depending on the type of management port on SIOC 1. adapter card installed. Cisco UCS C3160 Rack Server Installation and Service Guide OL-32062-01...
When you rack and cable the system, be sure to allow enough slack in the power and other cables so that the system can be pulled out on the slide rails far enough to allow clearance for opening the top covers. Cisco UCS C3160 Rack Server Installation and Service Guide OL-32062-01...
Page 4
Server node Power supplies (four, redundant as 2+2) See also Components Inside the Server Node, page 1-5. Drive expander module 3.5-inch drives (up to four in the optional drive expander module) Cisco UCS C3160 Rack Server Installation and Service Guide OL-32062-01...
DIMMs (8 sockets for each CPU, 16 total) Cisco modular RAID controller card with SuperCap power module (backup) attached CPUs and heat sinks (two) Internal USB port for USB thumb-drive (accessible with the node cover on) Cisco UCS C3160 Rack Server Installation and Service Guide OL-32062-01...
The view shown is with the cover of the module removed. Figure 1-5 Replaceable Components Inside the System I/O Controller RTC battery CR 1632 Adapter card (either dual-port 10 Gb SFP+ or quad-port 1 Gb RJ-45) Cisco UCS C3160 Rack Server Installation and Service Guide OL-32062-01...
KVM cable, which provides two USB, one VGA, and one serial connector. Internal USB The system includes one internal USB 2.0 slot inside the server node. Power Two or four power supplies, 1050 W each (hot-swappable and redundant as 2+2). Cisco UCS C3160 Rack Server Installation and Service Guide OL-32062-01...
Page 8
Cisco Integrated Management Controller (Cisco IMC) firmware. management Depending on your NIC mode settings, the Cisco IMC can be accessed through the dedicated management port, the 1-Gb LOM ports, or the 10-Gb LOM ports. 1. Hot-swappable = No preconditioning of the component is required before removal while the system is powered on.