Page 1
Operating and installation instructions Cooker hood To prevent the risk of accidents or damage to the appliance, it is essential to read these instructions before it is installed and used for the first time. en-GB M.-Nr. 10 940 830...
Contents Warning and Safety instructions................ 3 Caring for the environment ................ 12 Modes of operation ..................... 13 Guide to the appliance .................. 14 Operation...................... 16 Switching the fan on....................16 Select the power level ................... 16 Run-on time......................16 Switching the fan off ..................... 16 Switching the hob lighting on/off ................
They contain important notes on the safety, installation, use and maintenance of the appliance. Miele cannot be held liable for non- compliance with these instructions. Keep these instructions in a safe place and ensure that all users are familiar with the contents.
Page 4
Warning and Safety instructions The cooker hood can only be used by people with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, if they are supervised whilst using it, or have been shown how to use it in a safe way and recognise and understand the consequences of incorrect operation.
Page 5
Unauthorised installation, maintenance and repairs can cause considerable danger for the user. Installation, maintenance and repairs must only be carried out by a Miele authorised technician. A damaged appliance can be dangerous. Check it for visible signs of damage. Do not use a damaged appliance.
Page 6
Miele spare parts. If the electrical connection cable is faulty it must only be replaced by a Miele authorised service technician to protect the user from danger. During installation, maintenance and repair work, the appliance...
Page 7
Warning and Safety instructions Using at the same time as another heating appliance that depends on the air from the room Danger of toxic fumes! Great care should be taken when using the cooker hood in the same room or the same area of the house at the same time as another heating appliance that depends on the air from the room.
Page 8
Warning and Safety instructions In order to ensure safe operation and to prevent gases given off by the heating appliance from being drawn back into the room, when the cooker hood and the heater are both operated simultaneously, an underpressure in the room of 0.04 mbar (4 Pa) is the maximum permissible.
Page 9
Warning and Safety instructions Correct use Never use a naked flame beneath the cooker hood. To avoid the danger of fire, do not flambé or grill over a naked flame. When switched on, the cooker hood could draw flames into the filter. Fat deposits could ignite, presenting a fire hazard.
Page 10
Warning and Safety instructions Do not use the cooker hood without the filters in place. This way you will avoid the risk of grease and dirt getting into the appliance and hindering its smooth operation. The cooker hood can get very hot during cooking due to heat rising from the hob.
Page 11
Warning and Safety instructions Exhaust ducting must be of non-inflammable material. Suitable material is available from Miele specialist dealers or the Miele Spares Dept. The appliance must not be connected to a chimney or flue which is in use. Neither should it be connected to ducting which ventilates rooms with fireplaces.
/ recycling centre for electrical and electronic appliances, or contact your dealer or Miele for advice. You are also responsible (by law, depending on country) for deleting any personal data that may be stored on the appliance being disposed of.
Modes of operation Depending on the model of the cooker Recirculation mode hood, the following options are Recirculation mode cooker hoods available: require charcoal filters. These are available to purchase: see “Technical Extraction mode Data”. The air is drawn in and cleaned by the The air is drawn in and cleaned first by grease filters and directed outside.
Page 15
Guide to the appliance a Recirculation grille b Exhaust connection c Adjustable bracket d Open-out vapour canopy to which a furniture panel is fitted e Charcoal filter Accessory required for recirculation mode f Hob lighting g Grease filters h Controls...
Operation Switching the fan on Run-on time It is advisable to run the fan for a few Switch the fan on as soon as you start cooking. This is to ensure that vapours minutes after cooking has finished. are captured right from the start. This helps to remove any lingering ...
Energy saving tips This cooker hood operates very efficiently and economically. The following will help you to save even more energy when using it: – Ensure that there is sufficient ventilation in the kitchen when cooking. In extraction mode, if there is insufficient air flow the cooker hood cannot operate efficiently and this causes increased operating noise...
Cleaning and care General information Before proceeding with any maintenance or cleaning task, the The surfaces and controls are cooker hood must be disconnected susceptible to scratches and from the power supply, see “Warning abrasion. and safety instructions”. Please observe the following cleaning instructions.
Cleaning and care Important for the controls Grease filters The re-usable metal grease filters in the Do not leave soiling on the controls appliance remove solid particles for any length of time. (grease, dust, etc.) from the kitchen Otherwise they may suffer vapours, preventing soiling of the discolouration or damage.
Page 20
Cleaning and care Use a commercially available household dishwasher detergent. Select a dishwasher programme with a wash temperature between 50 °C and 65 °C. Depending on the detergent used, cleaning the filters in a dishwasher may cause the inside filter surfaces to become discoloured.
Fitting for the first time: fit an adapter booklet for contact details) or from your onto each side of the fan and turn to Miele dealer. The type of charcoal filter secure position in their holders. required is listed under "Technical data"...
Miele dealer or the Miele Service Department. Contact details for Miele are given at the end of this booklet. N.B. A call-out fee will be charged for service visits where the problem could have been resolved as described in these instructions.
Installation Before installation Dimensions Before installation, it is important to read the information given on the following pages as well as the “Warning and Safety instructions” at the beginning of this booklet. Installation recommendations – To achieve optimum vapour extraction, the cooker hood must be positioned centrally over the hob, not to the side.
Installation Safety distance between hob and cooker hood (S) When planning the installation height of your cooker hood, the minimum safety distance between the top of a cooker or hob and the bottom of the cooker hood is as follows, unless a greater distance is specified by the manufacturer of your cooking appliance.
Installation Fitting the furniture front Depth adjustment There are several holes on the There are two adjustable brackets at appliance's vapour plate for securing the top of the unit and an adjustable the front panel. A drilling template is trim at the bottom of the unit for setting supplied for correct positioning.
Installation Wall installation The cooker hood is fitted to the wall inbetween two wall units. Screws and plugs are supplied for this. Cut the drilling template to size and position against the wall. The top edge of the template indicates the top edge of the cooker hood.
Installation Height adjustment Adjusting screws in the brackets located at the top of the appliance are used for aligning the appliance with adjoining furniture units. Attach the vapour canopy with cabinet door fitted and then close it. It is possible to adjust the movement of the vapour canopy.
Installation Connecting to adjacent furniture units/fitting side panels The cooker hood is supplied with two screws on each side for securing it to adjacent furniture units or for fitting side panels. Remove the vapour canopy. Remove the grease filters. ...
Installation For air extraction mode For recirculation mode Fit the charcoal filters (see “Cleaning If your ducting system does not have a non-return flap, two are supplied with and care”). the cooker hood. One for 150 mm Electrical connection and one for 120 mm ducting. Refer to the notes in “Electrical connection”...
Electrical connection If the switch is not accessible after All electrical work should be installation (depending on country), an undertaken by a suitably qualified additional means of disconnection must and competent person in strict be provided for all poles. accordance with current national and For extra safety it is advisable to protect local safety regulations (BS 7671 in the appliance with a suitable residual...
Connection for air extraction If the exhaust is ducted through an If the cooker hood is used at the outside wall, a telescopic wall vent or same time as a heating appliance a roof vent (available as an optional that relies on oxygen from the same accessory) is recommended.
Technical data Fan motor 250 W Hob lighting 2 x 1.1 W Total connected load 252.2 W Voltage, frequency AC 230 V, 50 Hz Fuse rating Mains connection cable length 1.2 m Weight 11.8 kg Special accessories for recirculation mode Charcoal filter set DKF 14-1. The set contains two active charcoal filters.
Page 33
Data sheet for household cooker hoods In acc. with delegated regulation (EU) No. 65/2014 and regulation (EU) No. 66/2014 MIELE Model name / identifier DA 1867 Annual Energy Consumption (AEC 101,3 kWh/year hood Energy efficiency class Energy efficiency index (EEI...