Page 1
Operating and installation instructions Range Hoods To prevent the risk of accidents or damage to the appliance, it is essential to read these instructions before it is installed and used for the first time. en-SA M.-Nr. 10 630 850...
Contents Warning and Safety instructions................ 3 Caring for the environment ................ 12 Modes of operation ..................... 13 Guide to the appliance .................. 14 Operation...................... 16 Switching the fan on....................16 Switching the fan off ..................... 16 Switching the hob lighting on/off ................16 Energy saving tips ....................
They contain important notes on the safety, installation, use and maintenance of the appliance. Miele cannot be held liable for non- compliance with these instructions. Keep these instructions in a safe place and ensure that all users are familiar with the contents.
Page 4
Warning and Safety instructions The cooker hood can only be used by people with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, if they are supervised whilst using it, or have been shown how to use it in a safe way and recognise and understand the consequences of incorrect operation.
Page 5
Unauthorised installation, maintenance and repairs can cause considerable danger for the user. Installation, maintenance and repairs must only be carried out by a Miele authorised technician. A damaged appliance can be dangerous. Check it for visible signs of damage. Do not use a damaged appliance.
Page 6
Miele spare parts. If the electrical connection cable is faulty it must only be replaced by a Miele authorised service technician to protect the user from danger. During installation, maintenance and repair work, the appliance...
Page 7
Warning and Safety instructions Using at the same time as other heating appliances that depend on the air from the room Warning - danger of toxic fumes Great care should be taken when using the cooker hood at the same time and in the same room or area of the house as another heating appliance which depends on the air in the room.
Page 8
Warning and Safety instructions In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the cooker hood and the heater are in operation simultaneously, an underpressure in the room of 0.04 mbar (4 pa) is the maximum permissible.
Page 9
Warning and Safety instructions Correct use Never use a naked flame beneath the cooker hood. To avoid the danger of fire, do not flambé or grill over a naked flame. When switched on, the cooker hood could draw flames into the filter. Fat deposits could ignite, presenting a fire hazard.
Page 10
Warning and Safety instructions Do not use the cooker hood without the filters in place. This way you will avoid the risk of grease and dirt getting into the appliance and hindering its smooth operation. The cooker hood can get very hot during cooking due to heat rising from the hob.
Page 11
The steam could reach electrical components and cause a short circuit. Accessories Only use genuine original Miele accessories and spare parts with this appliance. Using accessories or spare parts from other manufacturers will invalidate the guarantee, and Miele cannot accept liability.
Please dispose of it at your local community waste collection / recycling centre or contact your Miele dealer for advice. Ensure that it presents no danger to children while being stored for disposal.
Page 15
Guide to the appliance a Chimney cover Optional accessories DRDC in various heights b Recirculation grille Only for recirculation mode with conversion kit DRUU c Canopy d Charcoal filters Optional accessory for recirculation mode. The charcoal filters are installed to the back of the baffle filters. e Baffle filters f Hob lighting g Controls...
Operation Switching the fan on Switching the fan off For light to heavy cooking vapours and It is advisable to run the fan for a few odours, select from power levels 1 to 3. minutes after cooking has finished to neutralise any lingering vapours and For short periods of cooking food with odours in the air.
Energy saving tips This cooker hood operates very efficiently and economically. The following will help you to save even more energy when using it: – Ensure that there is sufficient ventilation in the kitchen when cooking. In extraction mode, if there is insufficient air flow the cooker hood cannot operate efficiently and this causes increased operating noise...
Housing To help prevent re-soiling, a proprietary conditioning agent for General information stainless steel (available from Miele) can also be used. Follow the The surfaces and controls are manufacturer’s instructions on the susceptible to scratches and packaging.
Cleaning and care Removing the baffle filters Baffle filters The re-usable stainless steel baffle When handling a grease filter, be filters in the appliance remove solid careful not to drop it. particles (grease, dust, etc.) from the This can result in damage to the filter kitchen vapours, preventing soiling of and the hob below.
Page 20
Cleaning and care Cleaning the baffle filters by hand After cleaning Clean the baffle filters with a soft After cleaning, leave the baffle filters nylon brush in a mild solution of hot on an absorbent surface to dry. water and a little washing up liquid.
Page 21
Cleaning and care Fitting the baffle filters Push the baffle filter upwards and insert it at the bottom .
The charcoal filters are fitted to the back of the baffle filters. Charcoal filters are available to purchase from Miele. The type and designation can be found in chapter "Technical Data". Fitting/replacing charcoal filters Before fitting or replacing the...
Installation Before installation Installation instructions See enclosed Installation sheet for Before installation, it is important instructions on how to install this to read the information given on the appliance. following pages as well as the "Warning and Safety instructions" at the beginning of this booklet.
Page 25
Installation a 1 mounting rail for mounting the DAR 12xx on a wall. 2 self-locking screws, M6 x 16 mm for attaching the DAR 12xx to the b 2 mounting brackets mounting rail. for mounting the DAR 12xx on a wall. c 2 cover caps 4 screws, M4 x 11 mm with base and d 1 exhaust socket for exhaust ducting ...
Installation Appliance dimensions Extractor units DAR 1125, DAR 1135, DAR 1155. a Fixing points: the wall to which the range hood is fixed must be capable of supporting the weight of the appliance.
Page 27
Installation Wall range hoods DAR 1225, DAR 1235, DAR 1255 a Fixing points: the wall to which the range hood is fixed must be capable of supporting the weight of the appliance.
Installation Safety distance between hob and cooker hood (S) When planning the installation height of your cooker hood, the minimum safety distance between the top of a cooker or hob and the bottom of the cooker hood is as follows, unless a greater distance is specified by the manufacturer of your cooking appliance.
Installation Installation recommendations – When deciding on the safety distance between the hob and cooker hood, please note that a distance of 650 mm above electric cookers/hobs may be preferable to give more working space under the hood. – Account should also be taken of the height of the person who will be using the hood most often.
Connection for air extraction Any constriction of the airflow will If the cooker hood is used at the reduce extraction performance and same time as a heating appliance increase operating noise. that relies on oxygen from the same room, there is a risk in certain ...
Connection for air extraction Condensate trap Silencer To achieve even further reductions in noise levels, a special silencer (optional accessory) can be fitted in the ducting system. In addition to insulating the exhaust ducting, we recommend that a suitable Extraction mode condensate trap is also installed to collect and evaporate any condensate which may occur.
Page 33
Connection for air extraction Extraction mode with external motor To minimise noise from the motor in the kitchen, the silencer should be positioned in front of the external motor if possible, or, if the ducting is long, above the exhaust socket on the cooker hood .
Electrical connection Electrical connection All electrical work should be undertaken by a suitably qualified and competent electrician in strict accordance with current national and local safety and building code regulations. Please ensure the connection data (voltage and frequency) quoted on the data plate match the household mains supply.
In the event of a fault which you cannot remedy yourself, please contact your Miele dealer. Contact details your Miele dealer are given at the end of this booklet. N.B. A call-out fee will be charged for service visits where the problem could have been resolved as described in these instructions.
Technical data Fan motor* 200 W Hob lighting DAR 1125, 1225 2 x 3 W DAR 1135, 1235 3 x 3 W DAR 1155, 1255 4 x 3 W Total connected load* DAR 1125, 1225 206 W DAR 1135, 1235...
Page 37
Technical data Accessories required for recirculation mode Conversion kit from extraction mode to recirculation mode for DAR 1225: Conversion kit DRUU 30 and charcoal filter DKF 23-1 (contains 2 charcoal filters). Conversion kit from extraction mode to recirculation mode for DAR 1235: Conversion kit DRUU 36 and charcoal filter DKF 24-1 (contains 3 charcoal filters).
Page 40
DAR 1125, DAR 1135, DAR 1155 DAR 1225, DAR 1235, DAR 1255 DAR 1125 EXT, DAR 1135 EXT, DAR 1155 EXT DAR 1225 EXT, DAR 1235 EXT, DAR 1255 EXT en-SA M.-Nr. 10 630 850 / 00...