Miele EVS 7010 Operating And Installation Instructions page 27
Built-in vacuum drawer
Hide thumbs
Also See for EVS 7010:
- Operating and installation instructions (56 pages) ,
- Operating and installation instructions (60 pages) ,
- Operating and installation instructions (64 pages)
Table of Contents
Advertisement
c
b
a
Place the vacuum adapter over the
vacuum pump air intake valve .
Attach the connector to the con-
tainer lid. Make sure that the closure
of the lid is turned to "seal" (closed).
Switch the drawer on with the
sensor control.
The and sensor controls light up.
Touch the sensor control.
The and sensor controls go out.
The and sensor controls light up.
Touch the sensor control re-
peatedly until the segment for the re-
quired vacuum setting lights up.
Touch the sensor control.
The vacuuming process will start.
Leave the glass lid open for the entire
duration of the vacuuming process.
If an excessive amount of bubbles
form, you can cancel the vacuuming
process by pressing the sensor
control (see "Operation – Cancelling
the vacuuming process").
After the vacuuming process
A signal sounds.
Detach the connector from the con-
tainer lid. Make sure that the closure
of the lid is still turned to
"seal" (closed).
Remove the vacuum adapter from the
vacuum pump air intake valve.
Before starting a new vacuuming
process, check that the vacuum ad-
apter, the tube and the vacuum
chamber are clean and dry.
Remove any soiling or liquid residues
if necessary.
Operation
27
Hide quick links:
Advertisement
Table of Contents
