Advertisement
Quick Links
Ball Picker Mounting Bracket Kit
Workman
Model No. 07157
This product contains a chemical or chemicals known to the State of California to
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Ball-picker mount
Long brush-guard mount bracket (Gasoline
GTX and Electric GTX models only)
Short brush-guard mount bracket (MDX and
MDX-D models only)
Hex-head flange bolt (5/16 x 1 inch)
Flange nut (5/16 inch)
Carriage bolt (5/16 x 7/8 inch)
Lower brush-guard bracket (MDX and MDX-D
models only)
Hex-head flange bolt—3/8 x 1 inch (MDX and
MDX-D models only)
Flange nut—3/8 inch (MDX and MDX-D
models only)
No parts required
No parts required
No parts required
Note: Determine the left and right sides of the machine from the normal operating position.
© 2016—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
GTX or MDX Series Utility Vehicles
WARNING
CALIFORNIA
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
Qty.
1
1
1
4
8
2
1
4
4
–
–
–
Register at www.Toro.com.
Form No. 3402-394 Rev A
Installation Instructions
Use
Original Instructions (EN)
All Rights Reserved *3402-394* A
Printed in the USA
Advertisement
Related Manuals for Toro 07157
Summary of Contents for Toro 07157
- Page 1 Form No. 3402-394 Rev A Ball Picker Mounting Bracket Kit Workman ® GTX or MDX Series Utility Vehicles Model No. 07157 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
- Page 2 For MDX and MDX-D Models 5. Loosely attach the ball-picker mount to the short brush-guard mount bracket with 2 carriage bolts (5/16 1. Stop the machine on a level surface, set the parking x 7/8 inch) and 2 flange nuts (5/16 inch) as shown in brake, shut off the engine, and remove the key.
- Page 3 For Gasoline GTX and Electric 3. Loosely install the ball-picker mount to the long brush-guard mount bracket with 2 carriage bolts (5/16 GTX Models x 7/8 inch) and 2 flange nuts (5/16 inch) as shown in Figure 1. Stop the machine on a level surface, set the parking brake, shut off the engine, and remove the key.
- Page 4 Installing a Ball Picker to the Ball-Picker Mount On most ball pickers (from various manufacturers), mount the ball picker to the center hole on the ball-picker mount (Figure Note: It may be necessary to drill the hole larger or to create additional holes, depending on the ball picker being installed.