Table of Contents
Advertisement
Chapter 6: Solving Problems
Built-In Commands
2 Find out the IP address or hostname of the emulation probe or
the logic analysis system containing the emulation module.
3 Start the telnet program.
For example, if the hostname of the emulator probe is "emprobe", the
command might look like this:
telnet emprobe
Or, for example, if the hostname of the logic analysis system is "test2"
and you have only one emulation module installed, the command might
look like this:
telnet test2 6472
4 If you do not see a prompt, press the Return key a few times.
To exit from this telnet session, type Ctrl-d at the prompt.
To use the built-in commands
Here are a few commonly used built-in commands:
126
Advertisement
Table of Contents
