Related Manuals for LG ABNQ30GM2T2
Summary of Contents for LG ABNQ30GM2T2
- Page 1 OWNER’S MANUAL CONDITIONER Please read this manual carefully before operating your set and retain it for future reference. CEILING CONCEALED DUCT www.lg.com P/NO: MFL68120740 Copyright © 2020 LG Electronics Inc. All Rights Reserved...
- Page 2 TIPS FOR SAVING ENERGY TIPS FOR SAVING ENERGY Here are some tips that will help you minimize the power consumption when you use the air conditioner. You can use your air conditioner more efficiently by referring to the instructions below: •...
-
Page 3: Important Safety Instructions
SAFETY PRECAUTIONS IMPORTANT SAFETY INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE. Always comply with the following precautions to avoid dangerous situations and ensure peak performance of your product WARNING It can result in serious injury or death when the directions are ignored CAUTION It can result in minor injury or product damage when the directions are ignored WARNING... - Page 4 SAFETY PRECAUTIONS • Do not let the air conditioner run for a long time when the humidity is very high and a door or a win- dow is left open. Moisture may condense and wet or damage furniture. Operation • Take care to ensure that power cable could not be pulled out or damaged during operation. - There is risk of fire or electric shock.
- Page 5 SAFETY PRECAUTIONS CAUTION Installation • Always check for gas (refrigerant) pressure after installation or repair of product. - Low refrigerant levels may cause failure of product. • Install the drain hose to ensure that water is drained away properly. - A bad connection may cause water leakage. •...
-
Page 6: Table Of Contents
TABLE OF CONTENTS TABLE OF CONTENTS TIPS FOR SAVING ENERGY IMPORTANT SAFETY INSTRUCTIONS BEFORE USE Preparing for operation Usage Cleaning and maintenance Service PRODUCT INTRODUCTION Name and function of parts Wired Remote Controller (Accessory: PQRCUC2W) OPERATING INSTRUCTIONS Cooling Mode - Standard Operation Heating Mode(Heat pump model only) Dehumidification Mode Auto Operation Mode... -
Page 7: Before Use
BEFORE USE BEFORE USE Preparing for operation • Contact an installation specialist for installation. • Use a dedicated circuit. Usage • Being exposed to direct airflow for an extended period of time could be hazardous to your health. Do not expose occupants, pets, or plants to direct airflow for extended periods of time. •... -
Page 8: Product Introduction
PRODUCT INTRODUCTION PRODUCT INTRODUCTION Name and function of parts Air intake vents Air outlet Remote vents Controller 1: Indoor unit 2: Outdoor unit 3: Remote controller 4: Inlet air 5: Discharge air 6: Refrigerant piping, connection electric wire 7: Drain pipe 8: Ground wire wire to ground outdoor unit to prevent electrical shocks. -
Page 9: Wired Remote Controller (Accessory: Pqrcuc2W)
PRODUCT INTRODUCTION Wired Remote Controller (Accessory: PQRCUC2W 1 Display panel for control 2 Button for mode selection 3 Power button 4 Wind speed setting button 5 Temperature setting button When the wired controller is powered on, all function icons will be displayed on the display panel for three seconds. -
Page 10: Operating Instructions
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS Cooling Mode - Standard Operation It cools the room by comfortable and clean wind. Press the button to start the cooling operation. Press the temperature button and set the desired temperature below the room temperature. Press the button once to increase the desired temperature by 0.5 ℃... -
Page 11: Heating Mode(Heat Pump Model Only)
OPERATING INSTRUCTIONS Heating Mode(Heat pump model only) supplies warm air to the room. Press the key to run the machine, then press the key to select the heating mode. Set the desired temperature to be higher than the current room temperature. Pressing the button once will increase the desired temperature by 0.5 °... -
Page 12: Dehumidification Mode
OPERATING INSTRUCTIONS Dehumidification Mode It removes humidity while air-cooling weakly. Press the key to run the machine, press key to select the dehumidification mode. When dehumidification mode is selected, “dH” will be displayed in the window as shown on the left figure. - When this mode is running, the temperature setting cannot be adjusted. -
Page 13: Auto Operation Mode
OPERATING INSTRUCTIONS Auto Operation Mode Press the key to run the machine, then press the key to select the automatic operation mode. "Automatic mode switch" – the heat pump mode only In the automatic operation mode, when the set temperature is higher than the indoor temperature: →... -
Page 14: Fan Mode
OPERATING INSTRUCTIONS Fan Mode It blows the air without cold air. Press the key to run the machine, then press the key to select the air supply mode. When the air supply mode is selected, "Fn" will be displayed in the window as shown on the left figure. -
Page 15: Selection Of Air Flow Speed
OPERATING INSTRUCTIONS Selection of Air Flow speed This function is used to set the speed of the fan Press the key to select the desired air flow. - Pressing the key will cause the air flow speed changes in the following order. [Very weak →... -
Page 16: Room Temperature Detection
OPERATING INSTRUCTIONS Room temperature detection This function is used to check the room temperature. If pressing the key for more than 3 seconds, the room temperature will be displayed for 5 seconds before returning to the previous display. The room temperature may be different in temperature display depending on the setting of the room temperature sensing position of the wired controller. - Page 17 OPERATING INSTRUCTIONS Pressing the key and key at run time for more than 3 seconds can turn on the child lock function. - CL will be shown in the temperature display part for 3 seconds before returning to the previous mode in the initial setting of the child lock.
- Page 18 CARE AND MAINTENANCE CAUTION Before performing any maintenance, turn off the main power to the system. Never use any of the followings: Indoor Unit - Water hotter than 40°C Could cause deformation and/or discol- Grille, Case, and Remote Control oration. - Turn the system off before cleaning.
-
Page 19: When The Air Conditioner Is Not Going To Be Used For A Long Time
CARE AND MAINTENANCE When the air conditioner is Operation Tips not going to be used for a - Do not overcool the room. This is not good for your health and wastes long time. electricity. - Keep blinds or curtains closed. Operate the air conditioner on air circula- Do not let direct sunshine enter the room tion mode for 2 to 3 hours. -
Page 20: Troubleshooting Tips
CARE AND MAINTENANCE Troubleshooting Tips! Check the following points before requesting repairs or service..If the malfunction persist, please contact your dealer. Case Explanation • Have you made a mistake in timer operation? The air conditioner does not operate. • Has the fuse blown or has the circuit breaker been tripped? •...