Miele EVS 7010 Operating And Installation Instructions page 28
Built-in vacuum drawer
Hide thumbs
Also See for EVS 7010:
- Operating and installation instructions (56 pages) ,
- Operating and installation instructions (56 pages) ,
- Operating and installation instructions (64 pages)
Table of Contents
Advertisement
Operation
Place the lid on the container and
press it down.
Open the drawer and the glass lid.
c
b
a
Place the vacuum adapter over the
vacuum pump air intake valve .
Attach the connector to the
container lid. Make sure that the
closure of the lid is turned to
"SEAL" (closed).
Switch the drawer on with the On/
Off sensor control.
The segment bar indicator lights above
the and sensor controls light up.
Touch the sensor control.
The segment bar indicator lights above
the and sensor controls go out.
The segment bar indicator lights above
the and sensor controls light up.
Touch the sensor control
repeatedly until the segment bar
indicator light for the required
vacuum setting lights up.
Touch the sensor control.
28
The vacuum sealing process will start.
The sensor control goes out and
the sensor control lights up.
Leave the glass lid of the drawer open
for the entire duration of the vacuum
sealing process.
If an excessive amount of bubbles
form, you can cancel the vacuuming
process by pressing the sensor
control (see "Operation – Cancelling
the vacuum sealing process").
Advertisement
Table of Contents
