Initial commissioning
Displaying and setting the water
hardness level
Open the door.
Turn the dishwasher off with the
button, if it is turned on.
Press the button in and, while
holding it in, turn the dishwasher on
using the button.
Keep the button pressed in for at
least 4 seconds until the indicator
light comes on.
If this does not happen, start the
procedure from the beginning again.
Press the Program button 2 times.
The top left program indicator light will
flash rapidly 2 times at intervals.
22
The value set for the water hardness is
shown as a figure after in the time
display.
4 will start flashing in the time
display.
A water hardness of 14 gr/gal (14 °dH –
German scale) is set.
Use the button to set the water
hardness value in your area.
The dosage amount increases each
time you press the button. When the
highest value is reached, the setting
starts again from the beginning.
The setting is now saved.
Turn the dishwasher off with the
button.