Table of Contents
Advertisement
3.2 Assembly/Panel Removal
3.2.1
Stand removal
1. Remove the fixation screws [1] that secure the stand.
2. Take the stand bracket out from the set.
2
3.2.2 IR board Control Unit
1.
Unplug the connector from the SSB.
Caution: be careful, as these are very fragile connectors!
2.
Remove all the fixation screws [1],and connector [2] from the IR board control unit.
When defective, replace the whole unit.
3.2.2 Rear Cover
Warning: Disconnect the mains internal cable（MB to IR board） before removing the rear cover.
1. Remove fixation screws [2] and [3] that secure the back cover..
2. Gently lift the rear cover from the TV. Make sure that wires and cables are not damaged while lifting the rear cover from the set.
1
1
1
2
1
1
Advertisement
Table of Contents
