Aligning The Refrigeration Appliance - Miele K 31222 Ui Operating And Installation Instructions
Hide thumbs
Also See for K 31222 Ui:
- Operating and installation instructions (76 pages) ,
- Manual (11 pages) ,
- Operating and installation instructions (72 pages)
Table of Contents
Advertisement
On furniture with door fittings (e.g.
stubs, seals, etc.), the dimension of
these must be taken into account to
ensure there is a gap all round of
42 mm.
Pull the refrigeration appliance
forwards by the appropriate
dimension.
Check again to make sure there is a
gap of 42 mm to the front edges of
the door fittings.
Tip: If possible, remove the door fittings
and push the refrigeration appliance
into the niche until all fixing brackets at
the top and bottom are touching the
front edge of the housing unit side wall.
Installing the appliance
Aligning the refrigeration
appliance
When securing the refrigeration
appliance in the niche at the top, it
should sit lightly tensioned between
the floor and the worktop.
Adjust the front and rear feet
alternately according to the height of
the niche and make sure the
refrigeration appliance is correctly
aligned.
Proceed as follows:
Adjust both rear feet with appropriate
screws at the front right and left in the
appliance plinth using a flat-headed
screwdriver.
Use an Allen key to unscrew both
front feet.
57
Advertisement
Table of Contents
