Products must be used, installed and operated in accordance with this manual. You may not be able to claim on the AEG manufacturer’s warranty in the event that your product fault is due to failure to adhere to this manual.
ENGLISH The information can be found on the rating plate. Warning / Caution-Safety information General information and tips Environmental information Subject to change without notice. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damage that are the result of incorrect installation or usage.
Page 4
1.2 General Safety This appliance is intended to be used in household • and similar applications such as: farm houses; staff kitchen areas in shops, offices – and other working environments; by clients in hotels, motels, bed & breakfast and –...
ENGLISH 2. SAFETY INSTRUCTIONS 2.1 Installation 2.3 Water connection • Do not cause damage to the water WARNING! hoses. Only a qualified person must • Before connection to new pipes, pipes install this appliance. not used for a long time, where repair •...
• The appliance can release hot steam • Concerning the lamp(s) inside this if you open the door while a product and spare part lamps sold programme operates. separately: These lamps are intended to withstand extreme physical 2.5 Internal lighting...
ENGLISH Rinse aid dispenser Upper basket Detergent dispenser Cutlery drawer Lower basket 3.1 Internal light The lamp goes off when you close the door or switch the appliance off. The appliance has an internal lamp. It Otherwise, it goes off automatically after comes on when you open the door or some time to save energy.
Indicator Description Drying phase indicator. It is on when you select a programme with the dry‐ ing phase. It flashes when the drying phase operates. Delay indicator. It is on when you set the delay start. GlassCare indicator. ExtraPower indicator.
Page 9
ENGLISH Programme Dishwasher Degree of Programme phases Options load soil Crockery, • Prewash cutlery, pots, • Dishwashing 50 - pans 60 °C • Intermediate rinse • Final rinse 60 °C • Drying • AirDry None Cleaning • Cleaning 70 °C the appli‐...
Water (l) Energy (kWh) Duration (min) 1) 2) Programme 11.4 0.87 12.9 0.86 1) The pressure and the temperature of the water, the variations of the mains supply, the options, the quantity of dishes and the degree of soil can change the values.
ENGLISH How to activate SprayZone temperature of the water as well as wash time. The option operates within the designated area in the lower basket. Press Option until the indicator is on. SprayZone is suitable for dishwashing The display shows the updated items with stubborn soil, e.g.
CAUTION! drying phase and remains ajar. If children have access to the appliance, we advise to deactivate AirDry. The automatic opening of the door may pose a danger. How to deactivate AirDry Make sure the appliance is in user mode.
ENGLISH 8.1 How to fill the rinse aid CAUTION! dispenser Only use rinse aid designed specifically for dishwashers. 1. Open the lid (C). 2. Fill the dispenser (B) until the rinse aid reaches the marking ''MAX''. 3. Remove the spilled rinse aid with an absorbent cloth to prevent excessive foam formation.
Page 14
The upper ends of the two point of interruption. vertical ribs inside the compartment (B) indicate If the door is opened for the maximum level for filling more than 30 seconds the dispenser with gel (max.
ENGLISH automatically the appliance when it is not • When the programme is complete. operating. • After 5 minutes if a programme was not started. The function comes into operation: 10. HINTS AND TIPS 10.1 General • Use the appliance to wash dishwasher-safe items only.
Hot items can be At the end of the easily damaged. programme, water can still 3. First remove items from the lower remain on the inside basket, then from the upper basket. surfaces of the appliance. 11. CARE AND CLEANING 11.3 Cleaning the filters...
Page 17
ENGLISH 4. Wash the filters. CAUTION! An incorrect position of the filters can cause bad washing results and damage to the appliance. 11.4 Cleaning the lower spray We recommend to clean the lower spray arm regularly to prevent soil from clogging the holes.
Page 18
3. To install the spray arm back, press it downwards. 4. To install the spray arm back, press the spray arm upwards and simultaneously turn it counterclockwise until it locks into place.
ENGLISH from the holes. Run the water through the holes to wash soil particles away from the inside. 1. Move the upper basket to the lowest level to reach the spray arm more easily. 2. Pull out the cutlery drawer to the maximum.
Page 20
Problem and alarm code Possible solution The appliance does not fill • Make sure that the water tap is open. with water. • Make sure that the pressure of the water supply is not too low. For this information, contact your local water The display shows authority.
Page 21
ENGLISH Problem and alarm code Possible solution The appliance trips the cir‐ • The amperage is insufficient to supply simultaneously all cuit-beaker. the appliances in use. Check the socket amperage and the capacity of the meter or turn off one of the applian‐ ces in use.
Page 22
Problem Possible cause and solution There are whitish streaks or • The released quantity of rinse aid is too high. Adjust bluish layers on glasses and the rinse aid level to a lower level. dishes. • The quantity of detergent is too high.
ENGLISH 13. TECHNICAL INFORMATION Dimensions Width / height / depth (mm) 597 / 818 - 878 / 576 Voltage (V) 200 - 240 Electrical connection Frequency (Hz) 50 - 60 Wattage (W) 1550-2200 Water supply pressure bar (minimum and maximum) 0.5 - 10 kPa (minimum and maximum) 50 - 1000...
Page 24
Remove entire plastic There should be a minimum The hose should not be membrane from sink trap 2mm gap between the top of extended by more than spigot & fit drain hose to spigot the dishwasher and 2 metres or water pump-...
Page 25
ENGLISH Use the 4 internal fixing points if the opening is 600 mm. A combination of both fixing methods can be used if required. 14.5 Using the 2 external brackets 1. Install the brackets in the slots on the top of the appliance. This operation must be done before 3.
Page 26
2. Fix the appliance laterally with the In order to pass the safety valve through spacers and the screws supplied. the kitchen cabinets, an opening of at Make sure that the screws are tight. least 45 mm x 90 mm is needed.
Appliances, conditions of the product warranties purchased and used in Australia or for AEG Appliances. It is an important New Zealand and is in addition to document. Please keep it with your (and does not exclude, restrict, or...
Page 28
– the Appliance is modified the Appliance to and from Electrolux without authority from or its ASC. Travel and transportation Electrolux in writing; will be arranged by Electrolux as part – the Appliance’s serial number of any valid warranty claim.
Important Notice Before calling for service, please ensure that the steps listed in clause 8 above have been followed. SERVICE AUSTRALIA aeg.com/au FOR SERVICE FOR SPARE PARTS or to find the address of your nearest au‐ or to find the address of your nearest spare...