Summary of Contents for Barclay BCS
- Page 1 The BCS Light Controller 2022 Electrician’s Installation Guide Barclay Consulting Services Update: 9 February 2022...
-
Page 2: Table Of Contents
Table of Contents The Barclay Consulting Light Controller Installation ................2 BCS Installation Checklist ........................2 Detailed Installation steps ........................3 Unpacking the Equipment Enclosure ....................3 Identification of the Equipment Enclosure Installation Site ............3 Identification of the External Keypad Installation Site ..............3 Accessing Mains Power ........................ -
Page 3: The Barclay Consulting Light Controller Installation
Barclay Consulting Services (BCS) Light Controller Installation BCS Installation Checklist The court controller is mounted within a larger enclosure, together with the external relays that will drive the lighting contactors. This enclosure is designed to be installed by a local electrician. -
Page 4: Detailed Installation Steps
Remove the Equipment Enclosure top cover. Unscrew the acrylic safety shield to enable access to the power relays. Mount the Equipment Enclosure at the chosen location using the mounting holes indicated in the following diagram. BCS Light Controller – Standalone Operations... -
Page 5: Mounting The External Keypad
Mount the External Keypad at the chosen location using the mounting holes indicated in the following diagram. o The attached cable will need to be routed to the 6-way DIN connector on the left- hand side of the Light Controller. BCS Light Controller – Standalone Operations... -
Page 6: Connecting The Power Relays To The Existing Lighting Circuits
Powering on the System Turn the power on. The Light Controller should display “Controller Active” after about 20 seconds. The External Keypad should emit a low beep and the blue backlight should be visible. BCS Light Controller – Standalone Operations... -
Page 7: Setting The Initial Configuration
When auto mode is ON, commands 52 and 53 will not turn the lights ON or OFF. They are overridden by this control. To manually adjust lights auto mode must be set OFF. 0=n (OFF), 1=y (ON) BCS Light Controller – Standalone Operations... -
Page 8: Setting The Final Configuration
Requests the relay number and then deactivates all associated lights with that relay. Setting the Final Configuration This step should be performed by the system owner. The detailed configuration settings are described in the “BCS Light Controller Operations Manual”. BCS Light Controller – Standalone Operations... -
Page 9: Appendix A: Wiring Diagram
Appendix A: Wiring Diagram BCS Light Controller – Standalone Operations...