Page 1
OWNER’S MANUAL LED LCD TV Please read this manual carefully before operating your set and retain it for future reference. LS35** LS37** P/NO : MFL67360804 (1205-REV04) www.lg.com Printed in Korea...
TABLE OF CONTENTS TABLE OF CONTENTS LICENSES OPEN SOURCE SOFTWARE NOTICE SAFETY INSTRUCTIONS INSTALLATION PROCEDURE ASSEMBLING AND PREPARING Unpacking Parts and buttons Lifting and moving the TV Setting up the TV - Attaching the stand Mounting on a table Mounting on a wall Tidying cables MAKING CONNECTIONS Antenna connection...
In addition to the source code, all referred license terms, warranty disclaimers and copyright notices are available for download. LG Electronics will also provide open source code to you on CD-ROM for a charge covering the cost of performing such distribution (such as the cost of media, shipping and handling) upon email request to opensource@lge.com.
SAFETY INSTRUCTIONS SAFETY INSTRUCTIONS Please read these safety precautions carefully before using the product. WARNING y Do not place the TV and remote control in the following environments: - A location exposed to direct sunlight - An area with high humidity such as a bathroom - Near any heat source such as stoves and other devices that produce heat - Near kitchen counters or humidifiers where they can easily be exposed to steam or oil...
Page 5
SAFETY INSTRUCTIONS y Do not plug too many electrical devices into a single multiple electrical outlet. Otherwise, this may result in fire due to over-heating. y Do not drop the product or let it fall over when connecting external devices. Otherwise, this may result in injury or damage to the product.
Page 6
SAFETY INSTRUCTIONS y Do not disassemble, repair or modify the product at your own discretion. Fire or electric shock accident can occur. Contact the service center for check, calibration or repair. y If any of the following occur, unplug the product immediately and contact your local service centre.
Page 7
SAFETY INSTRUCTIONS CAUTION y Install the product where no radio wave occurs. y There should be enough distance between an outside antenna and power lines to keep the former from touching the latter even when the antenna falls. This may cause an electric shock. y Do not install the product on places such as unstable shelves or inclined surfaces.
Page 8
SAFETY INSTRUCTIONS y Do not turn the product On/Off by plugging-in or unplugging the power plug to the wall outlet. (Do not use the power plug for switch.) It may cause mechanical failure or could give an electric shock. y Please follow the installation instructions below to prevent the product from overheating.
Page 9
SAFETY INSTRUCTIONS y When moving or unpacking the product, work in pairs because the product is heavy. Otherwise, this may result in injury. y Contact the service center once a year to clean the internal parts of the product. Accumulated dust can cause mechanical failure. y Refer all servicing to qualified service personnel.
INSTALLATION PROCEDURE / ASSEMBLING AND PREPARING NOTE y Image shown may differ from your TV. y Your TV’s OSD (On Screen Display) may differ slightly from that shown in this manual. y The available menus and options may differ from the input source or product model that you are using.
Page 11
ASSEMBLING AND PREPARING Remote control and batteries (AAA) Owner’s manual (See p. 24) Polishing cloth (Depending on model) Cable holder Use this to remove dust (Depending on model) from the cabinet. (See p. 19) Screw for assembly Screw for assembly 2EA, P4 x 16 2EA, M4 x 14 (Only 22LS35**, 22LS37**)
Page 12
ASSEMBLING AND PREPARING NOTE y Antenna Isolator Installation Guide - Use this to install TV in a place where there is a voltage difference between TV Set and GND of antenna signal. » If there is a voltage difference between TV Set and GND of antenna signal, the antenna contact might be heated and excessive heat might cause an accident.
ASSEMBLING AND PREPARING Parts and buttons Screen Remote control and intelligent sensors Power indicator Speakers Touch buttons SETTINGS INPUT Touch Button Description Scrolls through the saved programmes. Adjusts the volume level. OK ꔉ Selects the highlighted menu option or confirms an input. SETTINGS Accesses the main menu, or saves your input and exits the menus.
ASSEMBLING AND PREPARING Lifting and moving the TV y When transporting a large TV, there should be at least 2 people. y When transporting the TV by hand, hold the TV Please note the following advice to prevent the as shown in the following illustration. TV from being scratched or damaged and for safe transportation regardless of its type and size.
ASSEMBLING AND PREPARING Setting up the TV Screw(Stand+Head) Attaching the stand M4 x 14 32LS35**, 32LS37** Image shown may differ from your TV. 22/26LS35**, 22/26LS37** Stand Body P4 x 16 Stand Body Stand Base Stand+Head) Screw(Stand+Head) M4 x 14 Stand Base 22LS35**, 26LS35**, Model...
ASSEMBLING AND PREPARING Mounting on a table CAUTION 1 Lift and tilt the TV into its upright position on a y When attaching the stand to the TV table. set, place the screen facing down on a - Leave a 10 cm (minimum) space from the cushioned table or flat surface to protect the wall for proper ventilation.
Page 17
ASSEMBLING AND PREPARING Securing the TV to a wall Securing the TV to a table (This feature is not available for all models.) (Only 32LS35**, 32LS37**) Fix the TV to a table to prevent from tilting forward, damage, and potential injury. To secure the TV to a table, insert and tighten the supplied screw on the rear of the stand.
When you attach the TV to other building provided with the Kensington security system or materials, please contact qualified personnel. visit http://www.kensington.com. LG recommends that wall mounting be performed by a qualified professional installer. Connect the Kensington security system cable between the TV and a table.
Holder. y If you install the TV on a ceiling or slanted wall, it may fall and result in severe injury. Use an authorized LG wall mount and contact the local dealer or qualified personnel. y Do not over tighten the screws as this may cause damage to the TV and void your warranty.
MAKING CONNECTIONS MAKING Antenna connection CONNECTIONS Connect the TV to a wall antenna socket with an RF cable (75 Ω). Connect various external devices to the TV and switch input modes to select an external device. For more information of external device’s connection, refer to the manual provided with each device.
MAKING CONNECTIONS Adapter connection HDMI connection (Only 22/26LS35**, 22/26LS37**) Transmits the digital video and audio signals from an external device to the TV. Connect the external device and the TV with the HDMI cable as shown. Choose any HDMI input port to connect. It does DC IN not matter which port you use.
MAKING CONNECTIONS Component connection Composite connection Transmits analog video and audio signals from an Transmits analog video and audio signals from an external device to the TV. Connect the external external device to the TV. Connect the external device and the TV with a component cable as device and the TV with the composite cable as shown.
MAKING CONNECTIONS USB connection Headphone connection Connect a USB storage device such as a USB (Only 22/26/32LS37**) flash memory, external hard drive, or a USB Transmits the headphone signal from the TV to memory card reader to the TV and access the My an external device.
REMOTE CONTROL REMOTE CONTROL The descriptions in this manual are based on the buttons on the remote control. Please read this manual carefully and use the TV correctly. To replace batteries, open the battery cover, replace batteries (1.5 V AAA) matching ends to the label inside the compartment, and close the battery cover.
USING THE USER GUIDE USING THE USER GUIDE User Guide allows you to more easily access the detailed TV information. User Guide 1 Press SETTINGS to access the main menus. OPTION > To set language 2 Press the RED button to access the Customer SETTING ...
MAINTENANCE / TROUBLESHOOTING MAINTENANCE Cleaning your TV Clean your TV regularly to keep the best performance and to extend the product lifespan. CAUTION y Make sure to turn the power off and disconnect the power cord and all other cables first. y When the TV is left unattended and unused for a long time, disconnect the power cord from the wall outlet to prevent possible damage from lightning or power surges.
For the power supply and power consumption, refer to the label attached to the product. 22LS35** 26LS35** 32LS35** 32LS3500-TB MODELS 22LS3500-TB 26LS3500-TB 32LS350Y-TB 22LS350Y-TB 26LS350Y-TB 32LS3590-TC 32LS359Y-TC 523.0 x 376.0 x 140.0 627.0 x 442.0 x 162.0 755.0 x 530.0 x 239.0 Dimensions With stand (mm) (W x H x D) Without stand(mm) 523.0 x 339.0 x 31.6...
Page 28
SPECIFICATIONS Digital TV Analogue TV New Zealand, Television System DVB-T PAL/SECAM-B/G/D/K, PAL-I Singapore BG : VHF/UHF 1 to 69, CATV 01 to 47 Programme UHF 21 to 69 I : VHF/UHF 1 to 69, CATV 01 to 47 Coverage DK : VHF/UHF 1 to 69, CATV 01 to 47 Australia Television System DVB-T...
Page 29
SPECIFICATIONS HDMI-DTV supported mode Resolution Horizontal Vertical Frequency Frequency (kHz) (Hz) 720x480 31.469 59.94 31.5 720x576 31.25 1280x720 37.5 44.96 59.94 1920x1080 33.72 59.94 33.75 28.125 26.97 23.97 33.716 29.976 33.75 30.00 56.25 67.43 59.94 67.5 Component port connecting information Component ports on the TV Y Video output ports on DVD player...
Page 30
Record the model number and serial number of (Only DTV) the TV. Refer to the label on the back cover and quote this information to your dealer when requiring any service. MODEL SERIAL...
Page 41
ﻣﺸﺨﺼﺎﺕ ﻓﻨﯽ ﺗﻠﻮﻳﺰﻳﻮﻥ ﺁﻧﺎﻟﻮگ ﺗﻠﻮﻳﺰﻳﻮﻥ ﺩﻳﺠﻴﺘﺎﻝ ﺯﻻﻧﺪﻧﻮ، ﺳﻨﮕﺎﭘﻮﺭ ﺳﻴﺴﺘﻢ ﺗﻠﻮﻳﺰﻳﻮﻥ PAL/SECAM-B/G/D/K, PAL-I DVB-T BG : VHF/UHF 1 to 69, CATV 01 to 47 ﭘﻮﺷﺶ ﺑﺮﻧﺎﻣﻪ I : VHF/UHF 1 to 69, CATV 01 to 47 UHF 21 to 69 DK : VHF/UHF 1 to 69, CATV 01 to 47 ﺳﻴﺴﺘﻢ...
Page 42
26LS35** 22LS35** 32LS3500-TB ﻣﺪﻝ 32LS350Y-TB 26LS3500-TB 22LS3500-TB 32LS3590-TC 26LS350Y-TB 22LS350Y-TB 32LS359Y-TC ﺍﺑﻌﺎﺩ (ﺑﺎ ﭘﺎﻳﻪ )ﻣﻴﻠﻴﻤﺘﺮ 239.0 x 530.0 x 755.0 162.0 x 442.0 x 627.0 140.0 x 376.0 x 523.0 (W x H x D) (ﺑﺪﻭﻥ ﭘﺎﻳﻪ )ﻣﻴﻠﻴﻤﺘﺮ 45.8 x 479.0 x 755.0 30.1 x 402.0 x 627.0...