Page 1
Built-in Hood for Electric Oven 922718 HOOT11E Level 922719 HOOT21E Level 922720 HOOV11E Level 922722 HOOS11E Level 922721 HOOS21E Level User manual* Original Instructions 231007 OM_HO_04_ELUX_EN.docx -...
Page 2
Foreword The installation, use and maintenance manual (hereinafter Manual) provides the user with information necessary for correct and safe use of the machine (or “appliance “). The following must not be considered a long and exacting list of warnings, but rather a set of instructions suitable for improving machine performance in every respect and, above all, preventing injury to persons and animals and damage to property due to improper operating procedures.
Contents WARNINGS AND SAFETY INFORMATION ............................... 4 General information ................................... 4 Personal Protective Equipment ................................. 5 General safety ....................................5 General safety rules ..................................6 Safety signs to be placed near the machine area ..........................7 Reasonably foreseeable improper use .............................. 8 GENERAL INFORMATION ..................................
A WARNINGS AND SAFETY INFORMATION General information To ensure safe use of the machine and a proper understanding of the manual it is necessary to be familiar with the terms and typographical conventions used in the documentation. The following symbols are used in the manual to indicate and identify the various types of hazards: WARNING Danger for the health and safety of operators.
Personal Protective Equipment Summary table of Personal Protective Equipment (PPE) to be used during the various stages of the machine's service life. Stage Protective Safety Gloves Glasses Safety garments footwear helmet — ● ○ — Transport — ● ○ — —...
• Do not use products (even if diluted) containing chlorine (sodium hypochlorite, hydrochloric or muriatic acid, etc.) to clean the appliance or the floor under it. • Do not spray water or use water jets or steam to clean the equipment. •...
Residual risk Description of hazardous situation Slipping or falling The operator can slip due to water or dirt on the floor Burns/abrasions (e.g. heating The operator inadvertently or intentionally touches some elements) components inside the machine without using protective gloves Electrocution Contact with live parts during maintenance operations carried out with the electrical panel powered...
End of use • When the appliance is no longer to be used, make it unusable by removing the mains power supply wiring. A.6 Reasonably foreseeable improper use Improper use is any use different from that specified in this manual. During machine operation, other types of work or activities deemed improper and that in general can involve risks for the safety of operators and damage to the appliance are not allowed.
They supplement the written information the permission of Electrolux Professional SpA. with an outline, but are not intended to be a detailed representation of the machine supplied. The...
Machine Hood installed above the oven Electrocution an accidental discharge of electric current on a human Manufacturer - Electrolux Professional SpA or body. any other service centre authorised by Electrolux Liability Professional SpA. Operator for an operator who has been...
D PRODUCT DESCRIPTION IMPORTANT The hood is intended specifically work with the Electrolux Professional SkyLine and Magistar Oven only; the manufacturer declines any responsibility in case of different use. Use – Introduction The instructions and information given in this manual are important for correct and optimum hood use. If required, further performance details can be obtained from the dealer.
Appliance overview 1. Main Board 2. Technical compartment – Closing Panel 3. Data plate 4. Oven/hood steam duct 5. Steam duct seal 6. Hood/oven interface cable 7. Steam Partializer for Oven modification 8. Water Tube for Oven modification 9. Mechanical fixing of hood to oven Oven control panel WARNING Before turning on the Oven, pay attention to the "Oven WARNINGS and Safety...
E OPERATION IMPORTANT The hood is intended specifically work with the Electrolux Professional SkyLine and Magistar Oven only; the manufacturer declines any responsibility in case of different use. “Odour Reduction” Hood mode “Air purifier” Hood mode Switch the oven ON pressing the ON/OFF button to The hood can be used as an air purifier.
Customer Care; to ensure constant machine efficiency, it is advisable to carry out the checks with the frequency given in the following table: Hood models HOOT11E 922718 Maintenance intervals HOOT21E 922719 HOOV11E 922720 HOOS21E 922721 HOOS11E...
Page 15
check the mechanical part, for cracks or deformation, tightening of screws, check the readability and condition of words, stickers and symbols and restore if necessary. check steam duct seal and restore if necessary. Safety signs Service Yearly check the readability and condition of safety signs. Electrical connection cable and related connectors Service Yearly...
The hood is equipped with a Demister and Water Appliance cleaning Separator Filter. It is located inside a left technical compartment, behind the Labyrinth Filter, in front of The oven has special cleaning programs; a pop-up the hood. window automatically appears when maintenance is Periodic cleaning is recommended required.
Page 17
F.2.4 TiO2 Filter replacement The hood is equipped with a TiO2 catalytic filter. It is located inside a central technical compartment, behind the labyrinth filter, in front of the hood. A pop-up window appears automatically on the oven display when cleaning or replacement is required. Its periodic replacement is recommended at the same time as replacing the UV-C lamps.
Page 18
F.2.5 UV-C Lamps - cleaning and/or replacement The hood is equipped with UV-C Lamps. They are located inside a central technical compartment, behind the Labyrinth Filter, in front of the hood. Periodic cleaning or restore are recommended. A pop-up window appears automatically on the oven display when cleaning or replacement is required.
F.2.6 Mini-Pleat Filter replacement F.3.1 UV-C Lamps cleaning done The hood is equipped with a Mini-Pleat Hight Efficiency Filter. Periodic cleaning or restore are recommended. It is located inside a central technical compartment, behind the Labyrinth Filter, in front of the hood.
F.3.2 UV-C Lamps replacement done Particular cleaning Condensate discharge system cleaning and efficiency check. Periodically clean the drain pipe, checking for any obstructions involving the draining of water. Brief Troubleshooting Guide Even with normal use, malfunctions can occur. The oven always displays a warning message describing the hood fault: WARNINGS A pop-up window automatically appears on the...
Page 21
NOTE! In case of malfunction, follow the indications given by the appliance; if required, contact Customer Care and carry out the following procedure: Disconnect the hood and the oven from the mains power supply; Disconnect the oven by means of the circuit breaker ahead of the it. Malfunction Error label Possible causes:...
G MACHINE SCRAPPING that the refrigerator components are special waste Waste storage assimilable with urban waste. At the end of the product's life-cycle, make sure it is not dispersed in the environment. The doors must be removed before scrapping the appliance. The symbol on the product SPECIAL waste materials can be stored temporarily indicates that this product should...