Safety and Warranty . . 40 system . . 17 www.lenovo.com . 40 Software provided by Lenovo . . 17 Help and service . 41 Using the documentation and diagnostic Chapter 5. Using the Setup Utility . . . 19 programs .
Chapter 9, “Getting information, help, and service,” on page 39 provides ® information about the wide variety of helpful resources available from Lenovo v Appendix A, “Manual modem commands,” on page 43 provides commands for manually programming your modem.
Where it is impossible to avoid reflections or to adjust the lighting, an antiglare filter placed over the screen might be helpful. However, these filters might affect the clarity of the image on the screen; try them only after you have exhausted other methods of reducing glare.
Page 14
2. Connect the keyboard cable to the appropriate keyboard connector, either the standard keyboard connector 1 or the Universal Serial Bus (USB) connector Note: Some models will have keyboards with a fingerprint reader. After you setup and turn on your computer, refer to the Access Help online help system for information about your fingerprint reader.
Page 15
5. If you have a modem, connect the modem using the following information. L IN L I N L I N L IN This illustration shows the two connections on the back of the computer that are needed to set up your modem. In the United States and other countries or regions that use the RJ-11 telephone outlet, attach one end of the telephone cable to the telephone and the other end to the telephone connector on the back of the computer.
Page 16
6. If you have audio devices, attach them using the following instructions. For more information about speakers, see steps 7 and 8. 1 Audio line-in This connector receives audio signals from an external audio connector device, such as a stereo system. 2 Audio line-out This connector sends audio signals from the computer to connector...
Page 17
9. Connect any additional devices that you have. Your computer might not have all connectors that are shown. 1 USB connector Use this connector to attach a device that requires a USB connection, such as a keyboard, mouse, scanner, printer, or personal digital assistant (PDA).
10. Connect the power cords to properly grounded electrical outlets. Note: For more information about connectors, refer to the Access Help online help system. See “Access Help” on page 40 for instructions on how to open the online help system. Turning on computer power Turn on the monitor and other external devices first, and then turn on the computer.
Your computer comes with antivirus software that you can use to detect and eliminate viruses. Lenovo provides a full version of antivirus software on your hard disk drive with a free 30-day subscription. After 30 days, you must renew the license to continue receiving the antivirus program updates.
Windows XP operating system, open the Start menu from the Windows desktop, click Shut down. Select Shut down from the drop down menu and click OK. Installing external options For information about installing external options for your computer, refer to ″Installing external options″...
Features This section provides an overview of the computer features and preinstalled software. System information The following information covers a variety of models. For information for your specific model, use the Setup Utility. See Chapter 5, “Using the Setup Utility,” on page 19. Microprocessor ®...
Page 22
1. The operating systems listed here are being certified or tested for compatibility at the time this publication goes to press. Additional operating systems might be identified by Lenovo as compatible with your computer following the publication of this booklet. Corrections and additions to this list are subject to change. To determine if an operating system has been certified or tested for compatibility, check the Web site of the operating system vendor.
Specifications This section lists the physical specifications for your computer. For machine type 6306 Dimensions Width: 175 mm (6.9 inches) Height: 402 mm (15.8 inches) Depth: 440 mm (17.3 inches) Weight Maximum configuration as shipped: 8.9 kg (19.8 lbs) Environment Air temperature: Operating: 10°...
Software provided with your computer may vary depending on your model. Lenovo Care The Lenovo Care program guides you to a host of information and tools to help you set up, understand, maintain, and enhance your computer. Rescue and Recovery...
Page 26
See “Online Books folder” on page 39 for more information about accessing the online books and the Lenovo Web site. User Guide...
v Contain at least one alphabetic character and one numeric character v Setup Utility program and hard disk drive passwords are not case sensitive v Not be your name or your user name v Not be a common word or a common name v Be significantly different from your previous password User Password When a User Password is set, the computer cannot be used until a valid password...
Note: If you do not want to save the settings, select Discard Changes and Exit. To set the Floppy A, do the following: 1. Start the Setup Utility program. See “Starting the Setup Utility program” on page 19. 2. From the Setup Utility program menu, select Devices → Floppy Drive Setup → Floppy A.
Advanced settings On some computer models, the Advanced settings menu includes a setting to enable or disable HyperThreading. This feature works only with HyperThreading-aware operating systems, such as Microsoft Windows Vista and Windows XP. The default setting for HyperThreading is Enabled. However, if you select Set Defaults and are using an operating system other than Windows Vista or Windows XP, your computer performance might be degraded.
Lenovo might make changes and enhancements to the POST/BIOS. When updates are released, they are available as downloadable files on the Lenovo Web site at http://www.lenovo.com. Instructions for using the POST/BIOS updates are available in a TXT file that is included with the update files. For most models, you can download either an update program to create a system-program-update (flash) diskette or an update program that can be run from the operating system.
Note: Due to the constant improvements made to the Web site, Web page content (including the links referenced in the following procedure) is subject to change. 1. From your browser, type http://www.lenovo.com/support in the address field and press Enter. 2. Locate the Downloadable files for your machine type as follows: a.
1. You can download the latest version of the PC-Doctor for Windows or PC-Doctor for DOS diagnostic programs from: http://www.lenovo.com/support/ Type your machine type into the Use Quick Path field and click Go to find the downloadable files that are specific to your computer.
PC-Doctor for DOS Depending upon your machine type and model, you have either PC-Doctor for DOS or PC-Doctor for Windows PE on your Lenovo computer. The PC-Doctor for DOS diagnostic program is part of the Rescue and Recovery workspace and runs independently of the Windows operating system.
PC-Doctor for Windows PE Depending upon your machine type and model, you either have PC-Doctor for DOS or PC-Doctor for Windows PE on your Lenovo computer. The PC-Doctor for Windows PE diagnostic program is part of the Rescue and Recovery workspace.
Cleaning the mouse This section provides instructions on how to clean an optical or non-optical mouse. Optical mouse An optical mouse uses a light-emitting diode (LED) and an optical sensor to navigate the pointer. If the pointer on the screen does not move smoothly with the optical mouse, you might need to clean the mouse.
Page 38
4 Ball cage To clean a mouse with a ball, follow the instructions below: 1. Turn off your computer. 2. Disconnect the mouse cable from the computer. 3. Turn the mouse upside down. Twist the retainer ring 1 to the unlocked position to remove the ball.
To create Product Recovery discs, do the following: 1. From the Windows desktop, click Start → All Programs → Lenovo Care → Create Recovery Media or Create Product Recovery Media. 2. Follow the instructions on the screen.
v Windows Vista: use Product Recovery discs to restore your computer to the original factory contents only. When using Product Recovery discs on Windows XP, you are given the option to enter the Rescue and Recovery workspace and choose from a variety of recovery operations.
To perform a backup operation using the Rescue and Recovery program, do the following: 1. From the Windows desktop, click Start → All Programs → Lenovo Care → Rescue and Recovery. The Rescue and Recovery program opens. 2. From the Rescue and Recovery main window, click Back up your hard drive to select backup operation options.
To create rescue media, do the following: 1. From the Windows desktop, click Start → All Programs → Lenovo Care → Create Recovery Media. 2. In the Rescue Media area, select the type of rescue media you want to create.
1. Start your computer and operating system. 2. Using an Internet browser, go to the following Web address: http://www.lenovo.com/think/support/site.wss/document.do?lndocid=MIGR-54483 3. Insert a diskette into diskette drive A. Information on the diskette will be erased and the diskette will be formatted appropriately.
The latest device drivers for factory-installed devices are also available at: http://www.lenovo.com/think/support/ To reinstall a device driver for a factory-installed device, do the following: 1. Start your computer and operating system.
1. With the computer turned off, repeatedly press and release the F1 key while you turn on the computer. 2. When the logo screen appears, or you hear a series of beeps, release the F1 key. 3. If you are prompted for a password, type your current password. 4.
Lenovo Care Lenovo Care contains information sources and tools designed to make computing easier and secure. Lenovo Care provides information about your computer and easy access to various technologies, such as: v Rescue and Recovery v Factory Recovery v System Update Note: Lenovo Care technologies are only available on select Lenovo computers.
To open Access Help, click Start → All Programs → Lenovo Care → Access Help. After you have opened Access Help, use the left panel to make a selection from the Contents or Index tab, or use the Search tab to find a particular word or phrase.
For instructions on using the diagnostic programs, see “Diagnostic programs” on page 26. Lenovo maintains pages on the World Wide Web where you can get the latest technical information and download device drivers and updates. To access these pages, go to: http://www.lenovo.com/support/ and follow the instructions.
Service availability and service name might vary by country or region. For more information about these services, go to the Lenovo Web site at: http://www.lenovo.com User Guide...
Page 52
Command Function Force modem off-hook (make busy) Note: H1 command is not supported for Italy Display product-identification code Factory ROM checksum test Internal memory test Firmware ID Reserved ID Low speaker volume Low speaker volume Medium speaker volume High speaker volume Internal speaker off Internal speaker on until carrier detected Internal speaker always on...
Extended AT commands Command Function &C_ &C0 Force Carrier Detect Signal High (ON) &C1 Turn on CD when remote carrier is present &D0 &D_ Modem ignores the DTR signal &D1 Modem returns to Command Mode after DTR toggle &D2 Modem hangs up, returns to the Command Mode after DTR toggle &D3 Resets modem after DTR toggle...
Command Function &V1 Display Last Connection Statistics &W_ &W0 Stores the active profile as Profile 0 &W1 Stores the active profile as Profile 1 Disable auto-retrain Enable auto-retrain +MS? Displays the current Select Modulation settings +MS=? Displays a list of supported Select Modulation options +MS=a,b,c,e,f Select modulation where: a=0, 1, 2, 3, 9, 10, 11,...
Fax Class 1 commands +FAE=n Data/Fax Auto Answer +FCLASS=n Service Class +FRH=n Receive data with HDLC framing Receive data +FRM=n +FRS=n Receive silence +FTH=n Transmit data with HDLC framing +FTM=n Transmit data +FTS=n Stop transmission and wait Fax Class 2 commands +FCLASS=n Services class.
+FPHCTO Phase C time out. +FPOLL Indicates polling request. +FPTS: Page transfer status. +FPTS= Page transfer status. +FREV? Identify revision. +FSPT Enable polling. +FTSI: Report the transmit station ID. Voice commands Select Baud Rate #BDR #CID Enable Caller ID detection and reporting format Select Data, Fax or Voice/Audio #CLS #MDL?
Page 57
Attention Switzerland User: If your Swisscom phone line does not have Taxsignal switched OFF, modem function may be impaired. The impairment may be resolved by a filter with the following specifications: Telekom PTT SCR-BE Taximpulssperrfilter-12kHz PTT Art. 444.112.7 Bakom 93.0291.Z.N Appendix A.
Macrovision Corporation. Reverse engineering or disassembly is prohibited. Trademarks The following terms are trademarks of Lenovo in the United States, other countries, or both: Lenovo The Lenovo logo...
Page 62
POST/BIOS update failure 24 introduction v software 31 recovery boot block 24 operations, backup and 32 Lenovo Care productivity center 39 problems, solving 37 Lenovo web site 40 repair diskette, creating and using 35 lighting, glare 3 workspace, rescue and 33...
Page 63
35 rescue media, creating and 34 Setup Utility 19 utility program, starting 19 video subsystem 13 viewing and changing settings 19 voice, commands 48 warranty information 40 web site, Lenovo 40 workspace, arranging 3 workspace, backup and recovery 33 Index...