Before using for the first time Water hardness reminder. Before using for the first time prime the ball valve as follows: Any residual lubricants and water from testing still in the machine should be flushed out as follows: Water hardness...
Preparing the wash load Pre-treating the washing Loading the drum Sort the laundry Maximum load weights are noted below: COTTONS ....5.0 kg MINIMUM IRON .
Adding detergent Water Softeners It is important to dispense the cor- rect amount, because..too little detergent results in the follow- ing: ...too much detergent results in the fol- lowing:...
Page 12
Fabric conditioners / starch formulations Texturiser and liquid starch formula- tions Powder starch To continue the programme:...
Changing the programme sequence Selecting a programme To omit a programme stage: To cancel a programme: To repeat a programme stage: To interrupt a programme: To change an incorrectly selected programme:...
Programmable functions Child-safety feature High water level (only in Cottons rinses) 5th Rinse for Cottons programme To change a programme:...
Page 19
Programmmable functions To programme an extra Function:...
Page 20
Programmable functions High water level 5th rinse Child - safety...
Page 21
Programmable functions Programme end Deleting the programmable function: After washing: – Rinses/Rinse hold indicator does not light up - no function is activated – Rinses/Rinse hold indicator lights up - proceed as for “Delet- ing the programmable function”. Exception: the Rinses/Rinse hold in- dicator lights up if the switch was set to “Cottons 95°C”.
Problem solving guide Programmes Check warning lamp flashes Cottons Max. 5 kg A selected programme does not The “Finish” indicator lamp is on, but begin the laundry in the machine has not The “On” indicator lamp does not light been washed. The water inlet system is blocked: The “On”...
Page 27
Problem solving guide Despite adequate water supply press- ure, the machine takes a long time to fill. The “Pre-wash” indicator lamp is Large amounts of unused detergent flashing. remain in the dispenser drawer. The “Main wash” indicator lamp flashes during, or after the end of a programme.
Page 28
Problem solving guide Programme selection The machine shakes during the spin Opening the drum door in the event cycle. of a power failure Cottons “Gentle action” Minimum iron “Short” Lime deposits are visible on the sur- face of the drum. Delicates Woollens Selecting the spin speed...
Page 29
Problem solving guide Grey greasy particles cling to Laundry washed with liquid deter- washed laundry. gent is not cleaned. Brown stains appear on the laundry after washing. After washing, knobbles (pilling) ap- pear on the fabric...
After sales service Adding detergent Water Softeners It is important to dispense the cor- rect amount, because..too little detergent results in the follow- ing: ...too much detergent results in the fol- lowing:...
Page 31
Installation Installation surface Removing the transit fitting. must Installation...
Page 32
Installation Preparing the wash load Pre-treating the washing Loading the drum Sort the laundry Maximum load weights are noted below: Washer-Dryer stack COTTONS ....5.0 kg MINIMUM IRON .
Page 33
Installation Levelling the machine Building under...
Electrical connection Warning and Safety Instructions ...when using your machine WARNING THIS APPLIANCE MUST BE EARTHED..before using for the first time...