Installing And Configuring The Disk Array; Setting The Host Mode And Host Group Mode For The Disk Array Ports - HP StorageWorks XP10000 - Disk Array Configuration Manual

Storageworks xp disk array configuration guide for ibm aix

Hide thumbs Also See for StorageWorks XP10000 - Disk Array:

Table of Contents

Installing and configuring the disk array

The HP service representative performs these tasks:

Assembling hardware and installing software

Loading the microcode updates

Installing and formatting devices

After these tasks are finished, you will use XP Remote Web Console, XP Command View Advanced

Edition Software, or XP Array Manager to complete the remaining tasks listed below. If you do not

have these programs, your HP service representative can perform these tasks for you.

After the disk array is installed, you must set the host mode for each host group that is configured on

a disk array port to match the host OS. Set the host mode using LUN Manager in XP Remote Web

Console (shown) or XP Command View Advanced Edition Software. If these are not available, the

HP service representative can set the host mode using the SVP. The host mode for AIX is 0F.

CAUTION:

The correct host mode must be set for all new installations (newly connected ports) to AIX hosts. Do

not select a mode other than 0F for AIX. Changing a host mode after the host has been connected is

disruptive and requires the server to be rebooted.

When a new host group is added, additional host group modes (options) may be configured. The

storage administrator must verify if an additional host group mode is required for the host group.

Installing and configuring AIX for the XP disk array

Table of Contents