Fabric And Connection Parameter Settings; Installing And Configuring The Host; Loading The Operating System And Software; Installing And Configuring The Fcas - HP StorageWorks XP10000 - Disk Array Configuration Manual
Disk array configuration guide for vmware
Hide thumbs
Also See for StorageWorks XP10000 - Disk Array:
- User manual (92 pages) ,
- Owner's manual (92 pages) ,
- Site preparation manual (80 pages)
Table of Contents
Advertisement
Fabric and connection parameter settings
Set each array port to FABRIC ON or OFF with connections of POINT-TO-POINT or FC-AL as shown
in the following table and figures. For detailed topology information, refer to the HP StorageWorks
SAN Design Reference Guide at:
http://www.hp.com/go/sandesign.
Figure 3 Point-to-point fabric topology example
.
Table 1 Fabric topology settings
Fabric parameter
OFF
ON
ON
OFF
Installing and configuring the host
This section explains how to install and configure Fibre Channel adapters (FCAs) that connect the
host to the disk array.
Loading the operating system and software
Follow the manufacturer's instructions to load the operating system and software onto the host. Load
all OS patches and configuration utilities supported by HP and the FCA manufacturer.
Installing and configuring the FCAs
Install and configure the Fibre Channel adapters using the FCA manufacturer's instructions.
Clustering and fabric zoning
If you plan to use clustering, install and configure the clustering software on the servers.
12
Installing and configuring VMware for the XP disk array
Connection parameter
FC-AL
Direct Fabric Attach
FC-AL
Direct Fabric Attach
Provides
NL-port (private arbitrated loop)
F-port (fabric port)
Not supported
Not supported
Advertisement
Table of Contents
