Table of Contents
Advertisement
STEREO
RECEIVER
5X-303R
S×-253R
5X-203
Thank
you
for
buying
this
Pioneer
product.
Please
read
through
these
operating
instructions
so
you
will
know
how
to
operate
your
model
properly.
After
you
have
finished
reading
the
instructions,
put
them
away
in a safe
place
for future
reference.
In some
countries
or regions,
the
shape
of the
power
plug
and
power
outlet
may
sometimes
differ
from
that
shown
in
the
explanatory
drawings.
However,
the
method
of
connecting-
and operating
the
unit
is the same.
WARNING:
TO
PREVENT
FIRE OR SHOCK
HAZARD,
DO NOT
EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
IMPORTANT
NOTICE
[For U.S. and Canadian models]
The
serial number
for this equipment
is located
on the rear panel.
Please
write
this
serial
number
on your
enclosed
warranty
card
and keep
it in a secure
area.
This
is for your
security.
[For Canadian
models]
CAUTION:
TO PREVENT ELECTRIC SHOCK
DO NOT USE THIS
(POLARIZED)PLUG WITH AN EXTENSION CORD, RECEP-
TACLE OR OTHER OUTLET UNLESS THE BLADES CAN
BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.
ATTENTION:
POUR PREVENIR LES CHOCS
ELECTRIQUES
NE PAS
UTILISER CETTE FICHE POLARISEE AVEC UN PROLON-
GATEUR UNE PRISE DE COURANT OU UNE AUTRE SOR-
TIE DE COURANT, SAUF Sl LES LAMES PEUVENT ETRE
INSEREES A FOND SANS EN LAISSER AUCUNE PARTIE
A DECOUVERT.
TWO VOLTAGE
SELECTOR
SWITCHES
Only
multi-voltage
models are
provided
with
these
switches.
U.S.
Canadian
models
are
not
provided
with
these
switches.
Main
voltages
in Saudi
Arabia
are 127
V and
220
V only.
Never
use this model
with
110
V setting
in Saudi
Arabia.
The
line voltage
selector
switches
are on the rear panel.
Before
your
model
is shipped
from the factory,
these
switches
are set to
the power
requirements
of the destination.
Check
that
they
are
set properly
before
plugging
the power
cord into the AC outlet.
If
the voltage
is not properly
set or if you move
to an area,where
the
voltage
requirements
differ,
adjust
the
selector
switches
as
follows.
1.
Disconnect
the power
cord.
2.
Use a medium-size
screwdriver.
3.
insert
the screwdriver
into the
groove
on the voltage
selec-
tors and adjust
so that the tip of the allow
points
to the vol-
tage
value
of your
area.
ilov
izo. izTv
Set the voltage
selector
switch
to the voltage
in your
area
(only
SX-303R).
i =ov
zzov
I ZO- I ZTv -_
r"
240v
Information
to User
Alteration
or modifications
carried
out without
appropriate
authorization
may
invalidate
the user's
right to oprerate
the
equipment.
CONTENTS
CHECKING ACCESSORY
ITEMS ....................................
3
CONNECTIONS ............................................................
3
REAR PANEL FACILITIES
.............................................
5
FRONT PANEL FACILITIES .............................................
6
REMOTE CONTROL UNIT FACILITIES
...........................
8
SETTING THE UNIT PRIOR TO OPERATION .....................
9
GRAPHIC EQUALIZER CONTROLS .................................
9
LISTENING TO THE BROADCAST
.................................
9
DIRECT ACCESS TUNING ..........................................
10
PRESET TUNING .........................................................
1 1
TO LISTEN TO OTHER MUSIC SOURCES ...............
,...... 13
TAPE RECORDING .......................................................
13
TROUBLESHOOTING
...................................................
14
SPECIFICATIONS
......................................................
1 5
PIONEER
The Art of Entertainment
Advertisement
Table of Contents
Related Manuals for Pioneer SX-303R
Summary of Contents for Pioneer SX-303R
- Page 1 STEREO RECEIVER 5X-303R S×-253R 5X-203 Thank buying this Pioneer product. Please read through these operating instructions will know operate your model properly. After have finished reading instructions, them away in a safe place for future reference. In some countries or regions,...
- Page 2 DAMAGE REQUIRING SERVICE appliance supporting structure, grounding of the lead-in WATER MOISTURE appliance should should be serviced by a Pioneer authorized service wire to an antenna discharge unit, size of grounding conductors, location antenna discharge unit, be used near water...
- Page 3 CHECKING ACCESSORY ITEMS FM Antenna Loop Antenna Remote control unit Power cord cell battery (SIZE "AA" (R6P)) I-SX-303R/SX-253R-] ESX-303R/SX-253R-I CONNECTIONS Setting up the AM Antenna • Insert the claw on the bottom of the antenna into the hole the leg. •...
- Page 4 CONNECTIONS When not using unit for a long period, disconnected the pow- A set the antenna on a level surface, and point in the direc- tion that gives optimum reception. • Do not install the antenna in locations where it touches M LOOP ANTENNA er cord.
-
Page 5: Rear Panel Facilities
W (0.8 6_ CONTROL OUT jacks (SX-303R, SX-253R only) MAX). equipment should be disconnected removing Connect this jack to other Pioneer components bearing mains plug from the wall socket when not in regular use, e.g. mark when... - Page 6 FRONT PANEL FACILITIES • illustration shows SX-303R. E3O_E31lr_nt_'a ÷ U POWER (STANDBY/ON) switch/STANDBY (_ S.BASS button (Super BASS) indicator(SX-303R, SX-253R) When this button is pressed, the bass sound will be emphasized. This is the switch for electric power. (_) RETURN button When set to the ON position, power...
- Page 7 FRONT PANEL FACILITIES 115_ OPERATION DISPLAY panel _99MPX MODE selector button Use to select the auto stereo mode or monaural mode when listen- (a) TAPE 2 monitor indicator. (b) MEMORY indicator ing to broadcasts. monaural mode has been selected (c) S.BASS indicator when MONO...
- Page 8 ON/OFF. DISC SELECT -/+: DISC selection. This remote control unit be used to operate some functions • Stop of Pioneer marked players and cassette deck. Play. _1_1, I_l_l: Track search. '.1_)RECEIVER POWER button NO TE: SLEEP button • Note...
- Page 9 SETTING THE UNIT PRIOR TO OPERATION • Before operating unit, be sure to set it as shown below. Set the TAPE 2 MONITOR but- to OFF (TAPE 2 indicator VOLUME control goes off). _MIN r' position. Press POWER switch !I _]_ ON position, ii _r____ - BALANCE...
- Page 10 DIRECT ACCESS TUNING [LISTENING TO BROADCASTS USING DIRECT ACCESS TUNING] tL7 '--''_ I'_I-I;' ooot £371-'-- - c,_ Press button oolo o Press button FOR MULTI-VOLTAGE MODEL When know the frequency of the desired station, the frequen- • When the CHANNEL STEP switch is set to FM...
-
Page 11: Frequency Presetting
PRESET TUNING I FREQUENCY PRESETTING I I_iSTENING BROADCASTS USING Allows three stations per STATION CALL button (press once, PRESET TUNING twice, or three times to select). oool i o ol 1. Press the POWER switch to the ON position. 1. Press the POWER switch to the ON position. - Page 12 TO LISTEN TO OTHER MUSIC SOURCES TAPE 2 Function MONITOR buttons button TAPE To listen to TAPE1/VCR /VCR To listen to a tape on the cas- 1. Press the POWER switch to the ON position. Also sette deck connected to TAPE turn on the power to the stereo components MONITOR jacks.
- Page 13 If the trouble cannot be rectified even after exercising checks listed below, ask your nearest PIONEER authorized service center ,our dealer to carry repair work. Cause Symptom Remedy Power does not come on even •...
- Page 14 SPECIFICATIONS Amplifier Section Tuner Section [SX-303R] Frequency range Continuous Average Power Output is 100 watts* When 10 kHz step ....... kHz to 1,600 When Hzkstep ......kHzto 1,602 per channel, min., at 8 ohms from 40 Hertz to Sensitivity 20,000 Hertz with no more than 0.9% total harmon- IHF, Loop...
- Page 15 When you find it damaged, ask your nearest chemicals on or near this unit, since these will corrode the PIONEER authorized service center or your dealer for a replace- surfaces. ment. Published...