Chapter 4. Completing The Parts Replacement; Cable Routing - Lenovo ThinkCentre 6137 Replacement Manual

Lenovo computer replacement guide

Hide thumbs Also See for ThinkCentre 6137:

Table of Contents

Chapter 4. Completing the parts replacement

After completing all parts replacements, you need to close the cover and reconnect

cables, such as power cords. Depending on the parts replaced, you might need to

confirm the updated information in the Setup Utility program. Refer to "Using the

Setup Utility" in the ThinkCentre User Guide for this product.

To complete the parts replacement:

1. Ensure that all components have been reassembled correctly and that no tools

2. Make sure that the cables are routed correctly before lowering the drive bay

Figure 32. Cable routing

3. Lower the drive bay assembly and position the drive locks to the locked

4. Close the computer cover.

5. If a cover lock is installed, lock the cover.

6. Reconnect the external cables and power cords to the computer. See "Locating

7. To update your configuration, see "Using the Setup Utility" in the ThinkCentre

or loose screws are left inside your computer. See "Locating components" on

page 8 for the location of various components.

assembly.

Important

Correctly route all power supply cables to avoid interference with the

drive bay assembly. Keep cables clear of the hinges and sides of the

computer chassis.

position. Otherwise, you cannot close the computer cover.

connectors on the rear of your computer" on page 6.

User Guide.

Table of Contents

Show Quick Links

Table of Contents