Contents Safety and warnings......................2-3 Introduction........................4 Installation........................5-8 Remote Controller ......................9-10 TV Operation........................11-14 TV Trouble shooting......................15...
SAFETY AND WARNINGS IMPORTANT SAFETY INSTRUCTION 1) Read these instructions. CAUTION 2) Keep these instructions. RISK OF ELECTRIC SHOCK DO NOT OPEN! 3) Heed all warnings. CAUTION 4) Follow all instructions. TO REDUCE THE RISK OF ELECTRIC SHOCK, DO 5) Do not use this apparatus near water. NOT REMOVE COVER (OR BACK).NO USER 6) Clean only with dry cloth.
Page 4
SAFETY AND WARNINGS High voltages are used in the operation of this television Never stand on, lean on, or suddenly push the television or receiver. Do not remove the cabinet back from your set. its stand. You should pay special attention to children. Refer servicing to qualified service personnel.
INTRODUCTION Accessories Main features AC Power Cord......1 Used as Television, display terminal,PC display High luminance,wide viewing angle Infrared Remote Controller.....1 Can store 99 TV programs Battery(AAA)........2 HDMI interface User s M anual........1 NICAM Main parameter Vie wing Picture Size(diagonal) 1366x768 Resolution Aspect Ratio 16 : 9...
INSTALLATION KEYBOARD Front panel SOURCE MENU VOL+ VOL- STANDBY 1 SOURCE Display the input source menu. 2 MENU D isplay main MENU. 3 CH+/CH- In TV mode press CH+ or CH- to change the channel up and down. In MENU mode, press CH+ or CH- to select items .
INSTALLATION STEPS: Be sure both the TV and computer are Power off. 1.Connect VGA and audio cable 2.Connect power cord 3.Power on the TV, switch to PC mode 4.Power on the PC This sequence is very important. HDMI VGA INPUT AC-INPUT AUDIO Y Pb Pr...
INSTALLATION AV EQUIPMENT This TV provides two groups of AV, one group of YPbPr for convenient connection to VCR, DVD or other video equipment. Please refer to the owner s manual of the equipment to be connected as well. You can use the input terminals on TV set rear as follows. VIDEO EQUIPMENT with YPbPr HDMI VGA INPUT...
REMOTE CONTROLLER MUTE POWER 1:POWER To set the TV to standby or power on. NICAM 2:NUMBER KEY: For direct access to programmes. For a 2 digit RECALL programme number, the second digit must be entered before the dash disappears. The number (in analog TV mode) is displayed for a few seconds.
Page 11
REMOTE CONTROLLER TELETEXT Teletext is an information system broadcast by certain channels which can be consulted like a newspaper. It also offers access to subtitles for viewers with hearing problems or who are not familiar with the transmission language(cable networks,satellite channels,etc.) You will obtain : Press : This is used to call or exit teletext modes.
TV OPERATION 3.OSD MENU 1. PICTURE MENU The first item of the MENU is PICTURE MENU. The third item of the MENU is OSD MENU. Y ou can adjust picture effect here, such as contrast, brightness, etc. Press to move, press to adjust.
Page 13
TV OPERATION 1).Colour system: adjust the colour system, Delete the channel Auto is remmended. Press 2 to select one channel. 2).Sound system:adjust the sound system. Press 1 to delete or press 2 to Please select the right sound system for cancel.
Page 14
TV OPERATION Source TV AV1 AV2 YPBPR HDMI1 HDMI2 YPBPR HDMI1 HDMI2 Note: :The two sources cannot do PIP/POP :The two sources can do PIP/POP. The sources in the table are optional. If any of these sources are not available in your unit, please ignore these sources.
Page 15
TV OPERATION USB Function:(optional) 1.MP3 menu 1.Entre the “USB” menu. ) Select the mp3 item of the USB menu, and press 1)Press the “source” button to entre the source menu. to entre the MP3 menu. 2)press to select the “USB”. )Press to entre folders or exit folder until Mp3 to entre the “USB”menu.
Trouble shooting Trouble phenomenon Picture Audio Inspection antenna position, direction Snow Noise or connection antenna position, direction Ghost or connection Normal audio electronic equipment,car/ Interfere Noise motorcycle,fluorescent light Volume(inspect wether the mute function on the remote Normal Picture Mute control are started , or audio system are correct or not) Power cord is not inserted Power switch is not opened...