English Important Safety Information These warnings are provided in the interest of safety. You read them carefully before installing or using MUST the appliance. Installation Service • It is mandatory that all operations required for the installation are carried out by a qualified or competent •...
Contents For the User This appliance complies with the following Important Safety Information E.E.C. Directives: 73/23 - 90/683 (Low Voltage Directive); Description of the appliance 89/336 (Electromagnetical Compatibility Directive); 93/68 (General Directives) Operation and subsequent modifications. Hints and tips Cleaning and maintenance MANUFACTURER: For the Installer ELECTROLUX HOME PRODUCTS ITALY S.p.A.
Operation Electric Hotplates To switch on a hotplate, turn the relevant control knob anticlockwise to the required heat setting. The control knob is numbered 1 - 6 0 - OFF 1 - Minimum 6 - Maximum. We recommend the plates are switched to maximum (6) for a short while to boost the plate, and then adjusted to the required setting.
Maintenance and Cleaning Before any maintenance or cleaning can be carried out, you must DISCONNECT the hob from the electricity supply. Never use steam or a steam cleaning machine to clean the appliance. The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool.
Instruction for the Installer Technical Data Rear hotplate 180 mm Ø 1,5 kW Frontl hotplate 145 mm Ø 1,0 kW Total energy 2,5 kW Voltage 230 V - 50 Hz Hob recess dimensions Length 490 mm. Width 270 mm. Insertion and assembly Dimensions for building in a kitchen unit are given in Fig.
Possibilities for insertion Building over a kitchen unit with door Proper arrangements must be taken in designing the furniture unit, in order to avoid any contact with the bottom of the hob which can be hot when in operation. The recommended solution is shown in Fig.
Electrical connection The appliance is designed to be connected to 230 V monophase electricity supply. The connection must be carried out in compliance with the laws and regulations in force. Before the appliance is connected: 1) check that the main fuse and the domestic installation can support the load (see the rating label);...