Inserting A Hot-Plug Memory Board - Fujitsu PRIMERGY RX600 S3 Operating Manual
Hide thumbs
Also See for PRIMERGY RX600 S3:
- User manual (305 pages) ,
- Operating manual (119 pages) ,
- Options manual (87 pages)
Table of Contents
Advertisement
Hot-plug Components
8.4.3
Inserting a Hot-plug Memory Board
Ê Align the ends in the card guides and slide the memory board into the
memory board slot.
1
2 3
Figure 30: Inserting a memory board
Ê Push the green handle (4) down into the fully locked position until the latch
(5) engages.
Ê Push the white attention button (2) to integrate the new memory board into
the system.
The attention LED (1) is flashing. The integration procedure is running.
Ê Wait until the attention LED (1) stops flashing and the green power LED (3)
is lighting.
The new memory board is integrated into the system.
I
If the green power LED (3) is not lighting, the new memory board was
rejected by the system, e.g. because its size did not match the current
configuration.
Ê Close the cover again (see
U41662-J-Z156-1-76
4
5
"Opening/Closing the Casing" on page
Memory boards
4
98).
87
Advertisement
Table of Contents
