Page 1
Operating and installation instructions Frost free fridge freezer with dynamic cooling KTN 4352 SD ed To avoid the risk of accidents or damage to the appliance, it is essential to read these instructions before it is installed or used for the first time.
Guide to the appliance d Super freeze button and indicator a Alarm button and indicator light light b Freezer section temperature e Refrigerator temperature display indicator light c Refrigerator section temperature display a Freezer section shelf b Dynamic cooling fan with On/Off switch c Butter and cheese compartment d Refrigerator shelves...
Caring for the environment Disposal of the packing Disposal of your old appliance material Please ensure that the appliance presents no danger to children while The transport and protective packing being stored for disposal. has been selected from materials which are environmentally friendly for It should be unplugged or disposal, and can normally be...
Warning and Safety instructions Technical safety This appliance complies with all This appliance contains the coolant relevant legal safety requirements. Isobutane (R600a), a natural gas Improper use can, however, present which is environmentally friendly. a risk of both personal injury and Although it is flammable, it does not material damage.
Page 7
Warning and Safety instructions Before connecting the appliance to Installation work, maintenance and the mains supply, make sure that repairs may only be carried out by the rating on the data plate suitably qualified and competent corresponds to the voltage and persons in accordance with national frequency of the household supply.
Page 8
Warning and Safety instructions Do not allow children to play with Observe the "use by" dates given the appliance, for example to climb on food to avoid the risk of food inside the drawers or to swing on the poisoning. door.
Warning and Safety instructions Disposal of your old appliance Do not block the ventilation gaps in the appliance as this would impair Before disposing of an old the efficiency of the appliance, increase appliance, first make the door latch the electricity consumption and could or lock unusable.
How to save energy Normal energy consumption Increased energy consumption Installation site In a ventilated room. In an enclosed, unventilated room. Protected from direct sunlight. In direct sunlight. Not situated near to a heat source Situated near to a heat source (radiator, oven).
Page 11
How to save energy Normal energy Increased energy consumption consumption Defrosting Defrost the freezer when a layer of A layer of ice hinders the cold ice one centimetre thick has built from reaching the frozen food, and causes an increase in energy consumption.
Switching on and off Before using for the first time display. The refrigerator interior light will come on if the door is opened. The stainless steel surface has a layer of protective foil to prevent scratching The alarm indicator light will light up. It during transportation.
The correct temperature . . . in the freezer section It is very important to set the correct temperature for storing food in the To freeze fresh food and to store frozen appliance. Micro-organisms will cause food for a long time, a temperature food which is not stored at the correct colder than -18 °C is required.
The correct temperature Temperature selection The temperatures for both the refrigerator section and for the freezer section are set using the same temperature selector. The temperature display on the control panel always shows the required temperature. To set the temperature in the refrigerator section to 5 °C, ^ turn the temperature selector clockwise from 0 until 5 lights up on...
Alarm Switching on the alarm system Your appliance has been fitted with a warning system which ensures that the The alarm system is always active. It temperature in the freezer section does not have to be switched on cannot rise unnoticed and to avoid manually.
Using Super freeze and Dynamic cooling Super freeze Switching on Super freeze Switch the Super freeze function on Freezing fresh food before putting fresh food into the freezer section. Fresh food should be frozen as quickly as possible. This way the nutritional Exceptions: value of the food, its vitamin content, appearance and taste are not impaired.
Using Super freeze and Dynamic cooling Dynamic cooling m Switching off Super freeze The Super freeze function will switch off When the Dynamic cooling function is automatically after approx. 65 hours. not switched on, the natural circulation The indicator light will go out and the of air in the appliance will cause appliance will continue running at different temperature zones in the...
Using the refrigerator efficiently Different storage zones Do not store explosive materials in Due to the natural circulation of the air the appliance or any products in the appliance, there are different containing propellants (e.g. spray temperature zones in the refrigerator. cans).
Using the refrigerator efficiently Storing food correctly Store food covered or packaged. This will prevent food smells or tastes from affecting other foods, and prevent food from drying out and also any cross-contamination of bacteria. The growth of bacteria, such as salmonella, can be avoided by setting the correct temperature and maintaining good standards of hygiene.
Adjusting the interior fittings Moving the shelves Adjusting the door shelves ^ Push the door shelf upwards, then The shelves can be adjusted according to the height of the food. remove it by pulling it forwards. ^ Raise the shelf at the front, pull it out ^ Replace the door shelf at the half way, and then lift it out.
Freezing and storing food Maximum freezing capacity Home freezing To ensure that fresh food placed in the Only freeze fresh food which is in a freezer freezes through to the core as good condition. quickly as possible, the maximum freezing capacity must not be Hints on home freezing exceeded.
Freezing and storing food ^ Make a note of the contents and the – Do not season fresh foods or blanched vegetables before date of freezing on the packaging. freezing. Only season cooked food lightly before freezing, but care Before placing food in the freezer should be taken as the taste of some ^ When freezing more than 1 kg of spices alters when frozen.
Freezing and storing food Defrosting Ice cubes Frozen food can be defrosted in (with or without release button different ways: depending on model) – in a microwave oven, – in an oven using the "Fan" or "Defrost" setting, – at room temperature, –...
Defrosting Refrigerator section Freezer section Condensate and frost can build up on This freezer is equipped with a "Frost the back wall of the refrigerator section free" system. The freezer section whilst it is in use. These are defrosts automatically. automatically removed and defrosted The moisture generated in the by the appliance.
E-Cloth ^ A microfibre "E-Cloth" is available Before cleaning from the Miele UK Spare Parts ^ Switch the appliance off by turning Department which is suitable for the temperature selector to "0" and cleaning surfaces such as stainless...
Cleaning and care Ventilation gaps After cleaning ^ The ventilation gaps should be ^ Replace all shelves and accessories cleaned regularly with a brush or in the refrigerator section. vacuum cleaner. A build-up of dust ^ Place food back in the refrigerator will increase the energy consumption section, close the doors, and switch of the appliance.
^ Check that the fuse is not defective because the freezer section is too and that the mains fuse has not warm. blown. If it has, contact the Miele Ser- ^ Is the room temperature lower than vice Department. the ambient temperature for which the appliance is designed? .
Page 28
Problem solving guide . . . food has frozen together..the interior light in the refrigerator section is not working. Use a blunt instrument, e.g. a spoon ^ Has the contact switch become handle or plastic scraper, to prise it apart carefully.
Page 29
^ Clean the condensate channel and drain hole. If you still cannot remedy the fault having followed these suggestions, please contact the Miele Service Department. To prevent unnecessary loss of temperature it is advisable not to open the doors while waiting for the...
Noises Normal noises What causes them Humming noise made by the motor (compressor). This noise can Brrrrr... get louder for brief periods when the motor is switching on. Blubb, blubb..A gurgling noise can be heard when coolant is circulating through the pipes.
In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – Your Miele Dealer – The Miele Service Department (see back cover for address). When contacting your Dealer or the Service Department, please quote the model and serial number of your appliance.
Electrical connection Electrical connection U.K. Non-rewireable plugs (BS 1363) All electrical work should be carried out The fuse cover must be re-fitted when by a suitably qualified and competent changing the fuse, and if the fuse cover person in accordance with local and is lost, the plug must not be used until a national safety regulations.
Installation temperature in the appliance to rise Do not place any appliance which with the risk of frozen food defrosting. gives off heat, such as a toaster or microwave oven, on top of this Ventilation appliance, as this would increase Air at the back of the appliance gets the appliance’s energy consumption.
Changing the door hinging ^ Remove the cover caps from the The appliance is supplied right hand hinged. If left hand door hinging is opposite side, and fit them into the required, follow the instructions below. empty holes. Removing the door handle: Changing over the doors: First the side section of the handle must be removed:...
Page 35
Changing the door hinging ^ Hang the upper appliance door on hinge pin i and close the appliance door. ^ Push middle hinge pin e from below through hinge bracket m into the upper appliance door. ^ Check that the upper door is correctly aligned.
Page 36
Changing the door hinging ^ Slide the side section of the handle Refitting the handles: d into the guides on the mounting Please make sure you follow the plate until it clicks into place. instructions below carefully when It is important to check that the side you refit the handle.
Building in the appliance The air inlet and outlet must not be covered or blocked in any way. They should be dusted on a regular basis. When installed next to a wall c a distance of approx. 50 mm is needed on the hinge side between the wall and the appliance b, so that the doors and the handles have sufficient space for...
Page 40
Alteration rights reserved / 2005 M.-Nr. 06 516 900 / 02 en - GB KTN 4352 SD ed...