Advertisement
Quick Links
HP Color LaserJet 2600 series -- Maintenance Kit Instructions
www.printertechs.com
Please note that installing the fuser in this maintenance kit is considered an
advanced installation procedure. If you have never done this before you will
want to follow the steps carefully and allow extra time for installation.
Because of the advanced nature of the fuser installation, we can only provide
limited technical support for this kit.
Here is the outline of installation steps:
Step #1 – Replace the separation pad.
Step #2 – Replace the pickup roller.
Step #3 – Replace the fuser.
Advertisement
Related Manuals for HP LASERJET 2600
Summary of Contents for HP LASERJET 2600
- Page 1 HP Color LaserJet 2600 series -- Maintenance Kit Instructions www.printertechs.com Please note that installing the fuser in this maintenance kit is considered an advanced installation procedure. If you have never done this before you will want to follow the steps carefully and allow extra time for installation.
-
Page 3: Paper Pickup Roller Removal And Replacement
Paper pickup roller removal and replacement Use the following procedures to remove the paper pickup roller. Open the front door. Remove the print cartridges. ENWW Removal and replacement procedures... - Page 4 Remove two (2) screws. Two (2) screws Remove the pre-transfer guide (RC1–5419–000CN). Use a small screwdriver to pull back on the tabs. Chapter 5 Removal and replacement ENWW...
- Page 7 Remove two (2) screws from the right cover assembly (RM1–1858–000CN). Two (2) screws Remove the right cover assembly, carefully disengaging the catches. Unplug the control panel cable. ENWW Removal and replacement procedures...
- Page 8 Insert a screwdriver to loosen the release tab on each side of the upper face cover. Remove the upper face cover (RC1–5174–000CN). Remove four (4) screws from the upper cover (RC1–5176–000CN). Chapter 5 Removal and replacement ENWW...
- Page 9 Lift up and remove the face-down cover (RC1–5173–000CN). Remove the output tray by releasing the tabs. Release tabs Unplug the harness from the fuser motor. ENWW Removal and replacement procedures...
- Page 10 Open two (2) clips and remove one (1) clip to remove the fuser connector. Open clips Remove clip Fuser connector Remove clip from the board by pulling up Chapter 5 Removal and replacement ENWW...
- Page 11 Unplug two (2) 3-pin optical encoder wires. Unplug the red high-voltage bias wire. Remove the thermistor wire. ENWW Removal and replacement procedures...
- Page 12 Remove the cables from the wiring harness. Remove three (3) screws from the fuser chassis. Three (3) screws Gently rocking if necessary, roll the fuser (RM1–1820–00CN for 110V) or (RM1–1821–000CB for 220V) forward to remove. Chapter 5 Removal and replacement ENWW...
- Page 13 Use the following procedure to replace the fuser. Align the fuser tabs with their respective holes. Complete replacement by following steps 1 through 18 above in reverse order. NOTE When replacing the right cover, align the tabs on the upper edge of the right cover and lower edge of the face-down cover with their respective slots.