A local telephone company may make changes in its communications facilities or procedure. If these changes could reasonably be expected to affect the use of the GW520 or compatibility with the net work, the telephone company is required to give advanced written notice to the user, allowing the user to take appropriate steps to maintain telephone service.
The pictures in this manual are for illustrative purposes only; your actual hardware may look slightly different. G. Interference and Attenuation GW520 may interfere with sensitive laboratory equipment, medical equipment, etc. Interference from unsuppressed engines or electric motors may cause problems. H. Electrostatic Sensitive Devices...
GW520 service manual GW520 service manual 3.2.5 GPIO map Over a hundred allowable resources, GW520 is using as follows except dedicated to SIM and Memory. GW520 GPIO(General Purpose Input/Output) Map, describing application, I/O state, and enable level, is shown in below table [Table 3.2.5-1] S-Gold®3H GPIO pin Map...
SD2_FB SD1_FBL SD2_FBL [Figure3.3.1-1] SM-Power 3 Circuit Diagram 3.3.2 Charging control - GW520 uses external charging IC which is BQ25040 Charging method : CC-CV Charger output voltage : 4.9 V Charging time : 2h 30m Charging current : 640 mA CV voltage : 4.2 V...
3. BB Circuit Technical brief GW520 service manual 3.5 SIM Interface GW520 supports 1.8V & 2.9V plug in SIM. SIM_IO, SIM_CLK, SIM_RST ports are used to communicate with S-Gold3H and the SIM power supply enabled by PMIC. SIM Interface SIM_CLK : SIM card reference clock...
3. BB Circuit Technical brief GW520 service manual 3.6 MICRO SD connector The Micro SD Memory Module has eight exposed contacts on one side. The S-Gold3H support two blocks of MMC interface. GW520 designed as first MMC. 2V8_VMME 2V62_VIO MMC_CARD...
GW520 service manual 3.7 Memory 2Gbit NAND Flash & 1Gbit DDR SDRAM employed on GW520 with 16 bit parallel data bus thru ADD(0) ~ ADD(24). The 1Gbit Nand Flash memory with DDR SDRAM stacked device family offers multiple high-performance solutions.
3.14 Bluetooth/FM (RBCA-B561A) General Description The GW520 device provides the highest level of integration for a mobile wireless system, with integrated Bluetooth 2.1, and FM receiver. The RBCA-B561A is a single module for Bluetooth 2.4GHz systems including enhanced data rates(EDR) to 3Mbits/s.
4. RF Circuit Technical Brief GW520 service manual [Figure 4.2.5-3] GW520 Front End Control Logic Table 4.3 WCDMA Part The single-chip transceiver is designed to fulfill the W-CDMA UTRA FDD system requirements for bands I, II, III, IV, V, VI and IX. It contains all active circuits required to simultaneously modulate an analog W-CDMA I/Q signal to the TX RF frequency and demodulate a RX RF W-CDMA signal to an I/Q baseband signal.