3. Technical Brief 3.2.7. GPIO map Over a hundred allowable resources, GD310 is using as follows except dedicated to SIM and Memory. GD310 GPIO(General Purpose Input/Output) Map, describing application, I/O state, and enable level, is shown in below table Table 5. S-Gold3 GPIO pin Map...
VIHdet (Vbat-0.8 ~ Vbat-0.3) the above-mentioned bit won’t be set. To support Remote power on function for factory mass production, applied an analog switch as following figure. As monitoring the RPWRON and Key matrix KP_OUT(2) & KP_IN (0), GD310 system recognize whether remote power on or End-key pushed...
3. Technical Brief 3.5. SIM & uSD interface GD310 supports 1.8V & 2.9V plug in SIM, SIM interface scheme is shown in (Figure 8). SIM_IO, SIM_CLK, SIM_RST ports are used to communicate with BBP(S-Gold3) and the SIM power supply enabled by PMIC.
3. Technical Brief 3.6. Memory 1Gbit Flash & 512Mbit DDRAM employed on GD310 with 8 & 16 bit parallel data bus thru ADD(0) ~ ADD(26). The 1Gbit Nand Flash memory with DDRAM stacked device family offers multiple high-performance solutions. ADD[16:28]...
Figure 16. JTAG & ETM(Embedded Trace Module) interface connector In case of GD310 mass production, the JTAG & ETM interface connector will not be mount on board. That is only for developing and software debugging purpose.( It will not be mounted on mass production...