Table of Contents
Advertisement
Installation and connection
Water drainage
The machine drains via a drain pump
with a delivery head of 1 metre. The
drain hose must not be kinked as this
restricts drainage. The swivel elbow at
the end of the hose can be turned in
either direction, or can be detached if
required, with a sharp twist and pull. If
required, the drain hose can be
extended to a length of 5 m. The
necessary parts can be purchased from
your Miele Dealer or Miele.
For a delivery head of more than 1 m
(up to a max. of 1.8 m) a replacement
drain pump will need to be fitted.
Please contact Miele or your Miele
Dealer for advice. If necessary, the
drain hose can be extended to a length
of 2.5 m. The necessary parts can be
purchased from your Miele Dealer or
Miele.
Drain hose connection:
1. Direct into a sink or basin.
Please note:
– Hook the hose over the edge and
secure.
– Make sure that the water can drain
away freely without hindrance.
Otherwise there is a risk of water
overflowing or of some of the
drained water being sucked back
into the washer-dryer.
2. Connected securely to a plastic drain
pipe with a rubber nipple. There is no
need to use a non-return valve.
3. Connected securely to a floor gully.
4. Connected securely to a standpipe.
100
Please note:
a Adapter
b Nut
c Hose clip
d End of the hose
Fit adapter to the sink drain outlet
using nut .
Attach the end of hose to adapter
.
Use a screwdriver to tighten hose clip
up close to the nut.
- Quick Links:
- Cleaning the Twindos System
Hide quick links:
Advertisement
Table of Contents
