Page 9
伸縮吸管 * g 軟管接駁插頭 h EasyLock 吸管 * i 伸縮吸管的脫扣按鈕 * j 塵格脫扣按鈕 k 吸力選擇器 l 地板吸塵頭 m 手挽 n 原廠 Miele 塵袋 o 摩打防護濾網 p AirClean 濾網 * q 「On/Off」(開/關)腳踏開關 r 停放插槽,可供在吸塵過程中暫停不用吸塵機時使用 s 電源線 t 電源線自動回捲的腳踏開關 u 塵袋更換指示器...
Page 27
P a r q u e t T w i s t e r X L 旋 轉 式 地 板 刷 罅隙吸咀,560 毫米 (SFD 20) (SBB 400-3) 靈活的罅隙吸咀,用於清潔難以觸及部 (僅在特定的國家供應) 位。 此地板刷採用天然馬鬃毛特製,用來快 傢俬吸咀,190 毫米 (SPD 10) 速清潔光滑硬地板和狹小縫隙。 加寬傢俬吸咀,用於清潔傢俬、床褥及 枕頭。 其他附件 MicroSet (SMC 20) 吸候靈活延伸...
Page 30
Contents Warning and Safety instructions................ 3 Caring for the environment .................. 7 Guide to the appliance .................. 8 Notes on Delegated Regulation (EU) No. 665/2013 and 666/2013 .... 10 Preparing for use .................... 11 Use........................ 15 Setting down and storing the vacuum cleaner.......... 17 Maintenance ......................
Warning and Safety instructions This vacuum cleaner complies with current safety requirements. Inappropriate use can, however, lead to personal injury and dam- age to property. To avoid the risk of personal injury and damage to the vacuum cleaner, please read these instructions carefully before using it for the first time.
Page 32
Reliable and safe operation of this vacuum cleaner can only be assured if it has been connected to the mains electricity supply. While the vacuum cleaner is under warranty, repairs should only be undertaken by a Miele authorised service technician. Otherwise the warranty will be invalidated.
Page 33
Do not use the vacuum cleaner if the cable is damaged. If the cable is damaged it must be replaced together with a complete cable rewind. For safety reasons this must only be done by Miele Service or a Miele authorised service technician.
Page 34
Only use genuine dustbags, filters and accessories with the “ORI- GINAL Miele” logo on them. Otherwise the manufacturer cannot guarantee the safety of the product. Miele cannot be held liable for damage caused by incorrect use or operation or by non-compliance with these Warning and Safety in- structions.
/ recycling centre for electrical and electronic ap- pliances, or contact your dealer or Miele for advice. You are also respons- ible (by law, depending on country) for deleting any personal data that may be stored on the appliance being disposed of.
Page 37
Telescopic suction tube release mechanism * j Dust compartment lid release catch k Suction power selector l Floorhead m Carrying handle n Original Miele dustbag o Motor protection filter p AirClean filter * q On/Off footswitch r Park System for pauses during vacuuming...
Fit the connector at the other end of Preparing for use the suction hose into the handle until Attach the suction hose it clicks into position. Your vacuum cleaner is fitted with one of the following suction tubes, depend- ing on model: –...
Page 40
Connect the handle to the suction tube Grasp the release mechanism and adjust the telescopic suction tube to the required length. Insert the handle into the suction tube until it clicks into position. To do Connect the suction tube to the this, line up the guides on the two floorhead pieces.
Page 41
If your vacuum cleaner is fitted with fil- ter b or c, you need to activate the ex- Miele offer a range of other floorheads, haust filter timestrip® change indicator. brushes and accessories for other types of flooring and special requirements.
Page 42
Using the accessories supplied Press the exhaust filter timestrip® change indicator. Dusting brush After approx. 10 - 15 seconds, a thin red line will appear in the left hand side Upholstery nozzle of the display. Crevice nozzle ...
Standard adjustable floorhead If vacuuming for longer than 30 minutes, the mains cable must be pulled out to its fullest extent. Other- wise there is a danger of overheating and damage. To rewind the cable Switch off at the wall socket and re- move the plug.
Page 44
During vacuuming Curtains, fabric Upholstery, cushions Cut pile carpets, rugs and runners Energy-saving vacuuming. This setting is also very quiet Loop pile carpet and rugs Hard flooring and heavily soiled carpets and rugs When vacuuming, in particular fine dust, e.g.
It is easy to reduce the suction power If your vacuum cleaner is on a slop- for a short time, e.g. to prevent rugs or ing surface, e.g. a ramp, other objects being sucked into the va- - retract the telescopic suction tube cuum cleaner.
The Miele filtration system consists of three components: Only use original Miele GN dustbags with a blue collar and original Miele fil- – Original Miele dustbag ters. These are identified by the “ORI- – Motor protection filter GINAL Miele” logo on the packaging.
Original Miele exhaust filters can also be purchased separately from the Miele Switch the vacuum cleaner on and Spare Parts Dept. or your Miele dealer. select the highest power setting. Please quote the model number of your Lift the floorhead off the floor a little.
How to replace the dustbag Pull the dustbag out by the grip on the collar. Press both release buttons at the side of the hose connector, and lift the Fit the new dustbag into the holder hose from the socket. as far as it will go.
AirClean suction socket on the vacuum cleaner until it clicks into position. Replace this filter every time you start a new packet of Miele dustbags. Every When to change the motor protection packet of original Miele dustbags con- filter tains one AirClean exhaust filter. Mul-...
Close the dust compartment lid. Insert a new exhaust filter, making it sure it goes in properly, then push it When to replace the Active AirClean down into position. 30/HEPA AirClean 30 filter? Replace this filter when the exhaust fil- ter timestrip®...
2. If you wish to replace exhaust filter b a AirClean or c with filter a, you must insert the b Active AirClean 30 (black) new filter into a filter grille * before in- c HEPA AirClean 30 (white) stalling. * Filter grille - see “Optional ac- Do not use more than one exhaust fil- cessories”...
Use a suitable screwdriver to remove the thread lifters from the slots. Fit new thread lifters. Replacement parts are available from your Miele dealer or from the Miele Spare Parts Dept. Cleaning and care Always disconnect the vacuum cleaner from the electrical supply be- fore cleaning it.
Problem solving guide Many malfunctions and faults that can occur in daily operation can be easily remedied. Time and money will be saved because a service call will not be needed. The following guide may help you to find the reason for a malfunction or a fault, and to correct it.
These and many other products can be ordered from the Miele webshop, the Please note that telephone calls may be Miele Spare Parts Dept. or your Miele monitored and recorded for training dealer. purposes and that a call-out charge will...
Page 55
Crevice nozzle, 560 mm (SFD 20) With natural bristles for vacuuming smooth hard floors and small gaps. Flexible crevice nozzle for vacuuming hard to reach places. Parquet Twister XL floorbrush with swivel action (SBB 400-3) Upholstery nozzle, 190 mm (SPD 10) (only available in selected countries) Extra wide upholstery nozzle for clean- ing upholstered furniture, mattresses...
Electrical connection for the All electrical work should be carried out by a suitably qualified and competent person in strict accordance with current national and local safety regulations (BS 7671 in the UK). The voltage and fre- quency are given on the data plate loc- ated underneath the vacuum cleaner.