Notes; Changing The Temperature Unit; Favourites Setting; Increasing The Life Of The Roller Cover - Miele PM 1210 Operating Instructions Manual
Commercial flatwork ironer
Hide thumbs
Also See for PM 1210:
- Operating instructions manual (42 pages) ,
- Quick manual (2 pages) ,
- Operating instructions manual (30 pages)
Table of Contents
Advertisement
Changing the temperature unit
The temperature unit display can be
changed from °C to °F by Miele Service.
Favourites setting
Using the "Favourites" button, the most
used combination of temperature and roller
speed can be saved so that they can be ac‐
cessed quickly and easily.
To save the desired parameters, press the
"Favourites" button until it flashes once.
The saved values are then accessed by
pressing the "Favourites" button briefly.
When you leave the "Favourites" function,
the previously saved values are restored
again.
Increasing the life of the roller cov‐
er
During longer pauses in ironing, switch off
the ironer or press the "On / Off" button
to enter Standby mode. This will considera‐
bly relieve the burden on the roller cover.
Avoid running the ironer without laundry.
Do not restrict ironing of smaller articles
to any one part of the roller. Make use of
the whole roller width.
If it is frequently used on only one side,
the heat is only absorbed on one side and
the roller cover will wear unevenly. If laun‐
dry is continuously fed in on one side of
the roller an infeed fault symbol will ap‐
pear in the display and an audible tone
will sound.
Power failure during ironing
In the event of a power failure, the heater
plate withdraws automatically. When power
is restored you need to restart the ironer by
pressing the button.
In the event of a longer power failure, the
ironer must be switched on again by press‐
ing the "On/Off" button, operating the fin‐
ger guard and pressing the button.
Peak load (optional accessory)
If peak load is active, the heater plate
switches off and "Temperature" and "Roller
speed" flash in the display. Ironing can be
continued using the residual heat in the
heater plate until the ironer goes into
"Pause" mode.
Notes
15
Advertisement
Table of Contents
