Illustrations; Commissioning; Assembling The Vacuum Cleaner; Connecting The Powerunit And The Suction Tube - Miele Duoflex HX1 Operating Instructions Manual
Cordless vacuum cleaner
Hide thumbs
Also See for Duoflex HX1:
- Quick start manual (2 pages) ,
- Operating instructions manual (104 pages)
Table of Contents
Advertisement
Available languages
Available languages
en
Illustrations
The illustrations referred to in the text
are shown on the fold-out pages at the
end of these operating instructions.
Commissioning
Assembling the vacuum cleaner
(Fig. 01)
Assemble the vacuum cleaner.
Connecting the PowerUnit and the
suction tube (Fig. 02 + 03)
Push the PowerUnit connector into
position in the suction tube until it
audibly clicks into place (Fig. 02).
Slide the sliding ring on the suction
tube down to separate the individual
sections from each other (Fig. 03).
Connecting the suction tube and the
electrobrush (Fig. 04 + 05)
Push the suction tube connector into
the electrobrush from above until it
audibly clicks into place (Fig. 04).
Slide the sliding ring on the electro-
brush down to separate the individual
sections from each other (Fig. 05).
General battery information
The rechargeable battery is supplied not
fully charged.
Charge the battery completely before
using it for the first time. Allow approx-
imately 3.5 hours for this.
Once the battery is fully charged, the
battery charging state indicator at the
top of the PowerUnit switches off to
conserve energy.
50
The maximum charging capacity is
only achieved once the battery has
been charged and run down approx.
five times.
A full charge provides enough power for
17 minutes if the vacuum cleaner is used
in its fully assembled state.
However, if you use the PowerUnit solo
(see "Operation" – "Using the
PowerUnit solo"), you can vacuum for
up to 55 minutes at a time.
The running time depends on the se-
lected power level, the flooring and
how the vacuum cleaner is used, as
well as on the degree of soiling of the
filter system.
Charging the battery (without wall
mounting) (Fig. 06)
You can charge the battery directly.
Before charging the battery for the first
time, you must read the information in
"Commissioning" – "General battery
information".
Plug the charging plug of the supplied
charging cable into the charging
socket on the bottom at the rear of
the PowerUnit.
Plug the charger into a power socket.
The charging process will start.
You can read more about this in "Bat-
tery charging state indicator (while
charging)".
Charging the battery (with wall mount-
ing)
You will need a suitable location near a
free power socket for mounting the ap-
pliance on the wall.
Advertisement
Chapters
Table of Contents
