End Of A Programme; Switching Off; Unloading The Crockery; Interrupting A Programme - Miele PFD 401 DOS Operating Instructions Manual
Commercial dishwasher
Hide thumbs
Also See for PFD 401 DOS:
- Operating instructions manual (168 pages) ,
- Operating instructions manual (100 pages) ,
- Operating instructions manual (128 pages)
Table of Contents
Advertisement
Operation
End of a programme
After a programme has ended normally, the
LED of the Start/Stop button will go out and
the following will appear on the display.
In addition to this, a buzzer will sound for
approx. 3 seconds (factory default setting).
The buzzer is repeated three times every
30 seconds. To change buzzer settings, see
"Volume".
Tap to acknowledge the display.
If system messages are present, they are
displayed afterwards, e.g. if the salt
container level or the level of the liquid
process chemicals containers was low
during the programme, or when the next
service is due. Every message needs to be
acknowledged individually by pressing OK.
Switching off
Press the button until the display turns
off.
Unloading the crockery
Crockery tends to break and chip more
easily when it is hot. Allow the items to cool
until they are comfortable enough to handle
before unloading them from the dishwasher.
If you open the door fully after switching off,
the crockery will cool much faster.
Unload the lower basket first, and then the
upper basket. This will prevent water drops
from the upper basket from falling onto the
crockery in the lower basket.
44
Interrupting a programme
A programme which is already running
should only be interrupted if strictly
necessary, e.g. if the load items are moving
significantly.
Danger of scalding, burning and
chemical burns
The load items, the load carrier and the
interior of the wash cabinet may be very
hot.
Steam may also escape when the door is
opened. Depending on the wash phase,
process chemicals may be dissolved
within the steam, which can cause
irritation and burns in the eyes and
respiratory tract.
A programme should only be interrupted if
strictly necessary.
Open the door slowly and carefully and
avoid contact with the steam that may
escape. Touch the load items at your own
risk.
Open the door.
Rearrange the load items so that they are
stable.
Close the door again to continue the
programme.
The programme automatically continues
from the point at which the interruption
occurred.
Temperature
compensation after
opened door:
Information
Programme will
continue in min
If the temperature inside the wash cabinet is
more than 50 °C at this point, the pressure
is equalised first. Then the programme
continues.
Advertisement
Table of Contents
