Electrical Connection - Miele CVA 7845 Operating And Installation Instructions
Built-in coffee machine
Hide thumbs
Also See for CVA 7845:
- Operating and installation instructions (120 pages) ,
- Installation manual (8 pages) ,
- Operating and installation instructions (120 pages)
Table of Contents
Advertisement
Installation
Connecting the water supply
Disconnect the coffee machine
from the mains power supply before
connecting it to the water supply.
Turn off the water supply at the tap
before connecting the coffee
machine to the water supply.
The tap must be easily accessible
after the machine has been built in.
To connect the coffee machine to the
water supply, a tap with a 3/4"
connection is required.
Check that a washer is present. Fit
one if necessary.
Connect the stainless steel hose to
the tap.
Ensure that it is screwed into position
correctly.
Turn on the tap slowly and check for
leaks.
Correct the position of the seal and
union if necessary.
You can now continue with the
installation of the coffee machine.
94
Electrical connection
Before connecting the appliance, make
sure that the connection data on the
data plate (voltage and frequency)
matches the mains electricity supply.
This data must correspond in order to
avoid the risk of damage to the
appliance. If in any doubt, consult a
qualified electrician.
The necessary connection information is
given on the data plate inside your
appliance.
The fuse rating must be at least 10 A.
The socket should be easily accessible.
If the socket is no longer accessible
after installation, an additional means of
disconnection must be provided for all
poles. Suitable means of disconnection
include switches with an all-pole
contact gap of at least 3 mm. These
include isolator switches, fuses and
relays.
Temporary or permanent operation with
a self-sufficient or non-mains
synchronous energy supply system (e.g.
isolated networks, back-up systems) is
possible. A requirement for the
operation is that the energy supply
system complies with all current local
and national requirements that apply to
stand-alone, solar and/or battery
systems.
The protective measures provided in the
domestic installation and in this Miele
product must also be assured in their
function and operation in isolated
operation or in non-mains synchronous
operation, or replaced with equivalent
measures in the installation.
The machine must not be used with so-
called energy-saving plugs. These
reduce the amount of energy supplied
to the machine, causing it to overheat.
Advertisement
Table of Contents
