Setting The System Option Modes; Configuring The Fibre Channel Ports; Host Group Modes (Options) - HP StorageWorks XP10000 - Disk Array Configuration Manual

Storageworks xp disk array configuration guide for hp-ux

Hide thumbs Also See for StorageWorks XP10000 - Disk Array:

Table of Contents

When a new host group is added, additional host group modes (options) may be configured. The

storage administrator must verify if an additional host group mode is required for the host group.

The following host group modes (options) are available for HP-UX:

Table 1 Host group modes (options)

Host

Group

Mode

Function

Deletion of Ghost LUN

Task retry ID enable

CAUTION:

Changing host group modes for ports where servers are already installed and configured is disruptive

and requires the server to be rebooted.

Setting the system option modes

The HP service representative sets the system option mode(s) based on the operating system and

software configuration of the host. Notify your HP representative if you install storage agnostic software

(such as backup or cluster software) that may require specific settings.

Configure the disk array Fibre Channel ports by using XP Remote Web Console (shown) or XP

Command View Advanced Edition Software. Select the settings for each port based on your storage

area network topology. Use switch zoning if you connect different types of hosts to the array through

the same switch.

Default

Inactive

XP Disk Array Configuration Guide for HP-UX

Comments

Previously MODE280

HP-UX 11.31 only

Table of Contents