Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Miele DA 289-4
Summary of Contents for Miele DA 289-4
- Page 1 Operating and installation instructions Cooker hood DA 289-4, DA 289-4 EXT en - GB, AU, NZ To avoid the risk of accidents or damage to this appliance it is essential to read these instructions before it is installed and used for the first time.
-
Page 2: Table Of Contents
Contents Caring for the environment ......... . 3 Warning and Safety instructions . -
Page 3: Caring For The Environment
Caring for the environment Disposal of the packing Disposal of your old appliance material Electrical and electronic appliances often contain materials which, if The transport and protective packing handled or disposed of incorrectly, has been selected from materials which could be potentially hazardous to are environmentally friendly for human health and to the environment. -
Page 4: Warning And Safety Instructions
Warning and Safety instructions This appliance is not intended for This appliance complies with all use by persons (including children) relevant local and national safety with reduced physical, sensory or requirements. Inappropriate use mental capabilities, or lack of can, however, lead to personal injury experience or knowledge, unless they and damage to property. - Page 5 Miele authorised person in accordance the data plate correspond with the with current national and local safety on-site electricity supply, otherwise the regulations.
- Page 6 These models may only be combined with a Miele external motor. This appliance may only be used in mobile installations such as ships, caravans, aircraft etc. if a risk...
- Page 7 The Miele DSM 400 control module appliance is switched off or vice versa. offers the possibility of combining other A ventilation brick alone is not generally components with the cooker hood (see sufficient to ensure safe ventilation.
-
Page 8: Correct Use
Warning and Safety instructions Correct use Do not use the cooker hood without the filters in place. This way you will Never use an open flame beneath avoid the risk of grease and dirt getting the cooker hood. To avoid the danger into the appliance and hindering its of fire, do not flambé... - Page 9 Safety regulations prohibit the fitting of a cooker hood over solid fuel stoves. All ducting, pipework and fittings must be of non-flammable material. These can be obtained from the Miele Spare Parts department or from builders' merchants. The appliance must not be connected to a chimney or vent flue which is in use.
-
Page 10: Guide To The Appliance
Guide to the appliance... -
Page 11: Guide To The Appliance
Guide to the appliance a Extension piece b Tower c Canopy d Touch controls e Hob lighting f Grease filter g Vapour plate h Touch control for the hob lighting This control switches the lighting on and off, and is also a dimmer switch. i On/Off touch control for the fan j Touch controls to select fan power level... -
Page 12: Modes Of Operation
Modes of operation The cooker hood works with . . . air extraction: . . . an external fan: ( ...EXT models only) The air is drawn in through the vapour plate, cleaned by the grease filter and The ...EXT models are designed to be directed outside. -
Page 13: Operation
The indicator lamp will come on. If the cooker hood has been connected to a window contact switch via the Miele DSM 400 ^ Press the run-on option control for control module, then the fan cannot approximately 10 seconds. The first be switched on if the window is shut. -
Page 14: Run-On Option
Operation Run-on option It is advisable to run the fan for a few minutes after cooking is finished to neutralise any lingering odours in the air. The indicator lamps for fan power levels I and IV will flash if the automatic The fan can be set to switch off switch-off for the Intensive setting is not automatically after either 5 or 15... -
Page 15: To Switch The Lighting On
Operation To switch the lighting on Safety cut-out The hob lighting can be switched on Should the cooker hood be left on, the and off independently of the fan. fan will switch off automatically after 10 hours. The lighting will remain on. ^ Briefly press the lighting control to switch on the hob lighting. -
Page 16: Filter Operating Hours Counter
Operation Filter operating hours counter The number of hours the appliance has been in operation is stored in memory. One or more of the indicator lamps for the – / + controls will flash. The number of flashing lamps shows the percentage of the operating time The indicator lamp for the grease filter which has already been used up. -
Page 17: Filter Operating Hours Counter
Operation Filter operating hours counter The operating hours counter for the grease filters is set at 30 hours. This can be lengthened or shortened to suit The – / + control lamps show the time the type of cooking you do. which has been set: You can choose from 20, 30, 40 or 50 1st lamp from the left = 20 hours... -
Page 18: Cleaning And Care
– the screw-out fuse is removed (in countries where this is applicable). Important for appliances with A range of Miele branded cleaning and stainless steel housing conditioning agents are available to (This infomation does not apply to the order through your Miele Dealer / controls). -
Page 19: Vapour Plate And Grease Filter
Cleaning and care Controls To avoid damaging the filter or the The controls may suffer hob below, make sure you hold the discolouration or damage if soiling is filter securely at all times when left on them for too long. handling it. - Page 20 Cleaning and care ^ With the vapour plate and grease Cleaning the grease filter by hand filter removed, clean off any residues ^ Clean the filter with a soft nylon brush of oil or fat from the now accessible in a mild solution of hot water and a housing and channel on the lower small amount of washing-up liquid.
-
Page 21: Changing A Halogen Lamp
Cleaning and care Changing a halogen lamp Disconnect the cooker hood from the mains supply by – switching it off at the wall socket and removing the plug, or – withdrawing the fuse from the fused spur connection unit, or –... -
Page 22: Appliance Dimensions
Appliance dimensions... -
Page 23: Safety Distance Between Hob And Cooker Hood (S)
Appliance dimensions The shaded areas 1) and 2) represent the wall or ceiling area for the vent cut-out, for fitting the connection socket and, in the case of EXT models, for feeding the connection cable through to an external fan. Connection for air extraction C 150 mm, or C 125 mm with reducing collar. -
Page 24: Installation
Installation Assembly parts... - Page 25 Installation a 3 protective sheets for use when fitting the tower. b Upper retaining plate 6 screws 3.5 x 9.5 mm for securing the extension piece. for securing the canopy and the filter housing c Middle retaining plate for securing the extension piece. d 2 hose clips for securing the exhaust ducting.
-
Page 26: Installation Instructions
Installation Dismantling Before installation, it is important to Should the appliance ever need to be read the information given on the dismantled, follow the installation following pages as well as the instructions in reverse order as Appliance dimensions and the described on the installation sheet. -
Page 27: Connection For Air Extraction
Connection for air extraction Important: To avoid the danger of If the exhaust ducting is secured to toxic fumes please observe the the exhaust stub by a hose clip, Warning and Safety instructions. ensure that it is fitted correctly. Do This is especially crucial when using not overtighten. -
Page 28: Condensate Trap
Connection for air extraction Silencer Important: If the exhaust ducting is to run through rooms, ceiling space etc. where there may be great variations in temperature between the different areas, the problem of condensation will need to be addressed. The exhaust ducting will need to be suitably insulated. -
Page 29: Electrical Connection
Electrical connection If the switch is not accessible after All electrical work should be installation (depending on country), an undertaken by a suitably qualified additional means of disconnection must and competent person in strict be provided for all poles. accordance with current national For extra safety it is advisable to install and local safety regulations a residual current device (RCD) with a... -
Page 30: Operation With Control Module Dsm 400
Operation with Control module DSM 400 The Miele DSM 400 Control module can If the control module is disconnected be used to combine the cooker hood in order to operate the cooker hood with other components. without the window contact switch It enables the following: (e.g. -
Page 31: Connection To A Light Switch
Operation with Control module DSM 400 Connection to a light switch The control module can be used to switch on the cooker hood lighting and also to dim it, depending on model, via a light switch in the house. Installation The tower needs to be removed before the control module can be fitted to the fan unit. -
Page 32: After Sales Service
In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – Your Miele Dealer / Chartered Agent – The Miele Customer Contact Centre (see back cover for address). When contacting your Dealer or the... -
Page 33: Technical Data
Weight EXT models: DA 289-4....33 kg Length of connection cable to external DA 289-4 EXT ....30 kg... - Page 36 Alteration rights reserved / 0208 M.-Nr. 06 783 600 / 05...