Miele DA 2360 Operating And Installation Instructions
Hide thumbs
Also See for DA 2360:
- Operating and installation instructions (40 pages) ,
- Operating and installation instructions (36 pages) ,
- Operating and installation instructions (40 pages)
Related Manuals for Miele DA 2360
Summary of Contents for Miele DA 2360
- Page 1 Operating and installation instructions Rangehood To prevent the risk of accidents or damage to the appliance, it is essential to read these instructions before it is installed and used for the first time. en-AU, NZ M.-Nr. 10 572 840...
-
Page 2: Table Of Contents
Contents Warning and Safety instructions................ 3 Caring for the environment ................ 12 Description of the functions ................ 13 Guide to the appliance .................. 14 Operation...................... 16 Switching the fan on....................16 Selecting a power setting..................16 Switching the fan off ..................... 16 Switching the cooktop lighting on/off .............. -
Page 3: Warning And Safety Instructions
It must only be used to extract vapours and remove odours from cooking. Any other usage is at the owner's risk. Miele cannot be held liable for damage resulting from incorrect or improper use or operation. Where a recirculation rangehood is fitted above a gas cooktop, please ensure that there is an adequate supply of fresh air into the room in which it is installed. - Page 4 Warning and Safety instructions This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning its use by a person responsible for their safety, and are able to recognise the dangers of misuse.
-
Page 5: Technical Safety
Repairs and other work by unqualified persons could be dangerous. Installation, maintenance work and repairs to electrical appliances must only be carried out by a Miele approved service technician. A damaged appliance can be dangerous. Check it for visible signs of damage. - Page 6 The manufacturer's warranty will be invalidated if the appliance is not repaired by a Miele approved service technician. Faulty components must only be replaced by genuine Miele spare parts. The manufacturer can only guarantee the safety of the appliance when Miele replacement parts are used.
- Page 7 Warning and Safety instructions Using at the same time as other heating appliances that depend on the air from the room Warning - danger of toxic fumes Great care should be taken when using the rangehood at the same time and in the same room or area of the house as another heating appliance which depends on the air in the room.
- Page 8 Warning and Safety instructions In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the rangehood and the heater are in operation simultaneously, an underpressure in the room of 0.04 mbar (4 pa) is the maximum permissible.
-
Page 9: Correct Use
Warning and Safety instructions Correct use Never use an open flame beneath the rangehood. To avoid the danger of fire, do not flambé or grill over an open flame. When switched on, the rangehood could draw flames into the filter. Fat deposits could ignite, presenting a fire hazard. -
Page 10: Correct Installation
Warning and Safety instructions Do not use the rangehood without the filters in place. This way you will avoid the risk of grease and dirt getting into the appliance and hindering its smooth operation. The rangehood can get very hot during cooking due to heat rising from the cooktop. - Page 11 Accessories Use only genuine original Miele spare parts. If spare parts or accessories from other manufacturers are used, the warranty will be invalidated, and Miele cannot accept liability.
-
Page 12: Caring For The Environment
Caring for the environment Disposal of the packing Disposing of your old material appliance The transport and protective packaging Electrical and electronic appliances has been selected from materials which often contain valuable materials. They are environmentally friendly for also contain specific materials, disposal, and can normally be recycled. -
Page 13: Description Of The Functions
Rangehoods set up for operation with an external motor have to be connected to a Miele external motor located in a suitable position outside the room in which the rangehood is installed. The external motor is linked to the... -
Page 14: Guide To The Appliance
Guide to the appliance... - Page 15 Cooktop lighting c Charcoal filters (x 2) (special accessory for recirculation mode) d Grease filters (DA 2360: 1 filter; DA 2390: 2 filters) e Controls f On/Off touch control for the fan g Touch controls to select the fan power setting...
-
Page 16: Operation
Operation Switching the fan on Switching the cooktop lighting on/off Press the On/Off touch control . The cooktop lighting can be switched The fan will switch on at setting 2. The on and off independently of the fan. symbol and 2 will light up in the power setting display. -
Page 17: Power Management
Operation Switching Power management on/off Power management You can deactivate Power The rangehood features a Power management. management system to help save This can, however, result in increased energy. The fan power setting is electricity consumption. reduced and the lighting is switched off automatically. -
Page 18: Safety Switch-Off
Operation Safety switch-off If Power management has been deactivated, the rangehood will switch itself off automatically after 12 hours if it has been left on (fan and cooktop lighting). Pressing the On/Off control for the fan or the lighting control will switch the rangehood back on again. -
Page 19: Energy Saving Tips
Energy saving tips This rangehood operates very efficiently and economically. The following will help you to save even more energy when using it: – Ensure that there is sufficient ventilation in the kitchen when cooking. In extraction mode, if there is insufficient air flow the rangehood cannot operate efficiently and this causes increased operating noise... -
Page 20: Cleaning And Care
Housing abrasive cleaning agent designed specifically for use on stainless steel, General e.g. Original Miele ceramic and stainless steel cooktop cleaner. The surfaces and controls are susceptible to scratches and To help prevent re-soiling, a abrasion. -
Page 21: Grease Filters
Cleaning and care Important for the controls Grease filters The re-usable metal grease filters in the Do not leave soiling on the controls appliance remove solid particles for any length of time. (grease, dust, etc.) from the kitchen Otherwise they may suffer vapours, preventing soiling of the discolouration or damage. - Page 22 Cleaning and care Cleaning the grease filters by hand After cleaning Clean the filters with a soft nylon After cleaning, leave the filters to dry brush in a mild solution of hot water on an absorbent surface before and a small amount of washing-up refitting them.
-
Page 23: Nosmell Active Charcoal Filters
Charcoal filters are available to order via the Miele Webshop (see end of this booklet for contact details) or directly from Miele. You will need to order a DKF 19-1 filter set. -
Page 24: Changing A Lamp
Only use lamps of the same type in the Screw the new lamp into the socket rangehood. and push it upwards. Please follow These lamps are available from Miele or the manufacturer's safety from specialist retailers. instructions. -
Page 25: Installation
Installation The rangehood is intended to be built Before installation into wall units, rangehood housing Before installation, it is important units, and above breakfast bars or to read the information given on the island areas. following pages as well as the ... -
Page 26: Assembly Parts
Installation Assembly parts... - Page 27 Installation a 1 exhaust socket for exhaust ducting 150 mm. b 1 reducing collar for exhaust ducting 125 mm (recommended for connection to existing 125 mm ducting only). c Conversion kit for recirculation mode (the conversion kit is not supplied, but is available as an 4 M5 x 40 mm screws, 4 washers, 4 optional accessory - see "Technical M5 nuts for securing the rangehood to...
-
Page 28: Appliance Dimensions
Installation Appliance dimensions The drawing is not to scale. - Page 29 Installation The drawing is not to scale.
-
Page 30: Safety Distance (S)
Installation a The ducting can also be connected at the back. b 222 x 89 mm flat exhaust ducting can be used as an alternative for ducting to the rear or to the side. c The rangehood is secured in the cut-out by clamps. This requires that the installation surface is made of a solid material, such as wood. -
Page 31: Installation Recommendations
Installation Installation recommendations – If positioned too high, extraction will be inefficient. – To achieve optimum vapour extraction, the rangehood must cover the cooktop. It should be positioned centrally over the cooktop, not to the side or to the rear. –... -
Page 32: Uneven Installation Surfaces
Installation Uneven installation surfaces If the installation surface is uneven making flush installation difficult, the frame can be realigned. Fit the rangehood as described on the installation sheet. Fit one of the screws supplied into Disconnect the rangehood from the each lamp holder. -
Page 33: Connection For Air Extraction
Connection for air extraction – If flat ducting is being used, the Before installation, it is important cross-sectional area must not be to read the information given on the smaller than the cross-sectional area following pages as well as the of the exhaust connection. -
Page 34: Silencer
Connection for air extraction If the exhaust ducting is to run Silencer through rooms, ceiling space etc. where there may be great variations in temperature between the different areas, the problem of condensation will need to be addressed. The exhaust ducting will need to be suitably insulated. - Page 35 Connection for air extraction Recirculation mode The silencer needs to be positioned between the exhaust connection and the exhaust grille . Ensure there is adequate space for fitting it. Air extraction with external motor To minimise noise from the motor in the kitchen, the silencer should be positioned in front of the external motor ...
-
Page 36: Electrical Connection
Electrical connection All electrical work must be undertaken by a suitably qualified and competent person in strict accordance with current national and local safety and building code regulations. Installation, repairs and other work by unqualified persons could be dangerous, for which the manufacturer cannot be held liable. -
Page 37: After Sales Service And Warranty
After sales service and warranty In the event of a fault which you cannot remedy yourself, please contact Miele. The contact details for Miele are given at the back of these instructions. When contacting Miele, please quote the model and serial number of your appliance. -
Page 38: Technical Data
1.5 m Weight DA 2360 11 kg DA 2390 13 kg DA 2360 EXT 6 kg DA 2390 EXT 8 kg * For EXT models, the rated load and extraction power will depend on the type of external motor fitted. - Page 39 Miele Experience Centre South Melbourne: Freemans Bay, Auckland 1011 206-210 Coventry Street South Melbourne, VIC 3205 Miele Experience Centre Auckland: Miele Experience Centre and Office Sydney: 8 College Hill 3 Skyline Place Freemans Bay, Auckland 1011 Frenchs Forest, NSW 2086 Telephone:...
- Page 40 DA 2360 DA 2390 DA 2360 EXT DA 2390 EXT en-AU, NZ M.-Nr. 10 572 840 / 00...