Table of Contents
Advertisement
Volume
Res. moisture dis-
play
Visibility paramet-
ers
Display off status
The date is set.
The volume for various sounds can be changed.
The volume can be changed for the following tones:
Finish tone
-
The finish tone signals the end of the drying programme.
Keypad tone
-
Welcome tone
-
-
Fault alarm
The fault tone signals a fault and can be switched off. The volume
of the fault tone cannot be adjusted.
In addition to displaying the drying level, the residual moisture can
also be indicated as a percentage.
Without % value
- Factory default:
With % value
-
Various parameters are offered/displayed when a programme is se-
lected. You can decide which parameters should not be displayed.
These parameters can then not be edited during programme selec-
tion.
Residual moisture
-
Duration
-
Low temperature
-
Anti-crease
-
Load size
-
-
Drying temperature
The display switches off to save energy; only the Start/Stop sensor
flashes slowly. You can change this setting.
Changing this setting leads to increased energy consumption.
Off
-
No switching off
On (10 min.) Not curr.prog.
-
The display will remain on during the programme sequence but will
go out 10 minutes after the end of the programme.
-
Logo (10 min.) Not curr.prog.
The display will remain on during the programme sequence but the
logo will light up 10 minutes after the end of the programme.
On after 10 min.
- Factory default:
The display is switched off after 10 minutes.
Tumble dryer supervisor level
117
Advertisement
Table of Contents
