Table of Contents
Advertisement
3.
Disconnect the touchpad antenna cable from the ZIF connector (3) on the bottom of the NFC
module.
4.
Remove the NFC module (4) from the computer. The module is secured with adhesive.
To install the NFC module, reverse this procedure.
Touchpad
To remove the touchpad, use this procedure and illustration.
Table 6-5
Touchpad description and part number
Description
Touchpad for use in models without NFC
Touchpad for use in models with NFC (includes NFC antenna)
Touchpad cable (included in Cable Kit)
Before removing the touchpad, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Remove the battery (see
Remove the touchpad:
1.
Disconnect the backlight cable from system board connector (1) and remove it from touchpad.
2.
Disconnect the system board cable from the ZIF connector (2) on the touchpad.
3.
Disconnect the cable from the ZIF connector (3) on the NFC module (select products only).
4.
Remove the seven Phillips M1.6 × 2.0 screws (4) that secure the touchpad to the computer.
52
Chapter 6 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page
Battery on page
48).
37).
Spare part number
N94631-001
N94632-001
N09040-001
37).
Advertisement
Table of Contents
