Table of Contents
Advertisement
5.
Remove the touchpad (5) from the computer.
NOTE:
the NFC module. The antenna is secured to the touchpad.
To install the touchpad, reverse this procedure.
Smart card reader
To remove the smart card reader from the top cover, use this procedure and illustration.
Table 6-6
Smart card reader description and part number
Description
Smart card reader
Smart card reader cable (available in the Cable Kit)
Before removing the smart card reader, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Remove the battery (see
4.
Remove the left speaker (see
Remove the smart card reader:
1.
Disconnect the cable from the ZIF connector (1) on the card reader.
2.
Remove the three Phillips M2.0 × 2.0 screws (2) from the card reader board.
If an NFC module is installed, disconnect the NFC antenna cable from the ZIF connector on
Bottom cover on page
Battery on page
Speakers on page
Preparation for disassembly on page
37).
48).
45).
Spare part number
N93634-001
N09040-001
37).
Smart card reader
53
Advertisement
Table of Contents
