hit counter code

How The Vacuum Cleaner Bag Change Indicator Works; Replacing The Dustbag; Replacing The Motor Protection Filter; Replacing The Airclean Exhaust Filter - Miele Classic C1 Operating Instructions Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 24
To check the airflow indicator
 Attach the standard adjustable floor-
head to the vacuum cleaner.
 Switch the vacuum cleaner on and se-
lect the highest power setting.
 Lift the floorhead off the floor a little.
How the vacuum cleaner bag change
indicator works
The filter change indicator is set for nor-
mal household dust. This generally con-
tains a mixture of dust, hair, threads,
carpet fluff, grit, etc.
However, if the vacuum cleaner has
been used to vacuum up fine dust, such
as drilling dust, sand, plaster dust or
flour, the pores of the vacuum cleaner
bag will become blocked very quickly.
The indicator will indicate that the va-
cuum cleaner bag is "full" even when it
is not. The vacuum cleaner bag must be
replaced if this is the case.
If, on the other hand, you vacuum up a
significant amount of hair, carpet lint,
etc., the vacuum cleaner bag will be full
to bursting before the indicator reacts.
Replacing the dustbag (Fig. 24)
 Press both release buttons at the side
of the hose connector, and lift the
connector from the suction opening
(Fig. 01).
 Pull the release catch upwards and
open the dust compartment lid as far
as it will go.
The dustbag has a flap which closes
automatically when the dust compart-
ment lid is raised to prevent any dust
escaping.
 Pull the dustbag out by the grip on
the collar.
 Fit the new dustbag into the holder
as far as it will go. Leave the dustbag
folded up when you take it out of the
box.
 Close the dust compartment lid se-
curely, making sure it clicks into posi-
tion. Take care not to trap the dustbag
when doing so.
A safety device prevents the lid closing
without a dustbag in place. Do not
force it.
 Insert the hose connector into the
suction opening on the vacuum
cleaner until it clicks into position.

Replacing the motor protection filter

(Fig. 25)
Replace the motor protection filter
whenever you start a new packet of
dustbags.
Every packet of original Miele dustbags
contains a motor protection filter. Mul-
tipacks contain 4 motor protection fil-
ters.
 Open the dust compartment lid.
 Pull the dustbag out by the grip on the
collar.
 Unclip the filter frame and replace the
motor protection filter.
 Close the filter frame.
 Fit the dustbag into the holder as far
as it will go.
 Close the dust compartment lid.

Replacing the AirClean exhaust filter

(Fig. 26)
Do not use more than one exhaust
filter at a time.
en
39

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hs12

Table of Contents