Page 1
Operating and installation instructions Frost-free freezer FN 9752 i en - GB To avoid the risk of accidents or damage to the appliance, it is essential to read these instructions before it is installed and used for the first time.
Guide to the appliance a Safety lock indicator light d Temperature selector buttons (+ for warmer; – for colder) b On/Off button e Super freeze button and indicator c Temperature display light f Alarm off button a Frost free system c Freezer drawers with freezer calendar b Freezer tray...
Caring for the environment Disposal of the packing Disposal of your old appliance material Electrical and electronic appliances often contain materials which, if The transport and protective packing handled or disposed of incorrectly, has been selected from materials which could be potentially hazardous to are environmentally friendly for human health and to the environment.
It must only be used as a domestic appliance to store deep frozen food, to freeze fresh food and to prepare ice. Any other usage is not supported by the manufacturer and could be dangerous. Miele cannot be held liable for damage resulting from incorrect or...
Warning and Safety instructions Technical safety room, there is the danger of combustible gases building up. Before setting up the appliance, For every 8 g of coolant at least 1 m check it for any externally visible room space is required. The amount of damage.
Page 8
Faulty components must only be suitably qualified and competent replaced by genuine Miele original person in strict accordance with current spare parts. The manufacturer can only national and local safety regulations.
Page 9
Warning and Safety instructions Correct use When cooling drinks quickly in the freezer, make sure bottles are not left in Never handle frozen food with wet for more than one hour, otherwise they hands. Your hands may freeze to the could burst, resulting in injury or frozen food.
Page 10
Warning and Safety instructions Disposal of your old freezer Do not block the ventilation gaps in the plinth or the top of the appliance Before disposing of an old housing unit as this would impair the appliance, first make the door latch or efficiency of the appliance, increase the lock unusable.
How to save energy Normal energy Increased energy consumption consumption Installation site In a ventilated room. In an enclosed, unventilated room. Protected from direct sunlight. In direct sunlight. Not situated near to a heat source Situated near to a heat source (radiator, oven).
Switching on and off Before using for the first time Safety lock ^ Clean the inside of the appliance and The safety lock can be activated to the accessories with warm water and prevent the appliance being switched a little washing-up liquid, and then off inadvertently.
Switching on and off ^ Press the On/Off button to come out of the setting mode. If you do not do this, the electronics will switch over to normal operation automatically after a couple of minutes. Switching off for longer periods of time If the appliance is not going to be used for a longer period of time, e.g.
The correct temperature Setting the temperature It is very important to set the correct temperature for storing food in the Use the two buttons underneath the appliance. Micro-organisms will cause temperature display to set the food which is not stored at the correct temperature for the freezer.
The correct temperature If you have adjusted the temperature, This loss of coldness is no cause for wait for approx. 6 hours if the concern in the following circumstances: appliance is not very full and for – when the door has been left open for approx.
Page 16
The correct temperature ^ Press one of the temperature selector buttons repeatedly until appears in the display. ^ Press the Super freeze button again. lights up in the display. ^ You can now adjust the level of brightness by pressing the temperature selector buttons.
Alarm Activating the alarm system Your appliance has been fitted with a warning system which ensures that the The alarm system is always active. It temperature in the freezer cannot rise does not have to be switched on unnoticed and to avoid energy being manually.
Super freeze Super freeze Switching off Super freeze Switch the Super freeze function on The Super freeze function will switch off before putting fresh food into the automatically after a minimum of 30 freezer. hours and a maximum of 65 hours. The indicator light will go out and the This helps food to freeze quickly and appliance will run at normal power...
Freezing and storing food Maximum freezing capacity Storing frozen food To ensure that fresh food placed in the When buying frozen food to store in freezer freezes through to the core as your freezer, check quickly as possible, the maximum –...
Freezing and storing food Home freezing lightly before freezing, but care should be taken as the taste of some Only freeze fresh food which is in a spices alters when frozen. good condition. – Do not place hot foods or drinks in Hints on home freezing the freezer.
Freezing and storing food Freezing large items Before placing food in the freezer ^ When freezing more than 2 kg of If you wish to freeze large items such fresh food, switch on the Super as a turkey or game, the glass cold freeze function for some time before plates between the drawers can be placing the food in the freezer (see...
Freezing and storing food 6-8 months: Never re-freeze partially or fully Pork, veal, poultry defrosted food. Consume defrosted 10-12 months: food as soon as possible as it will Beef, fruit, vegetables lose its nutritional value and spoil if left for too long. Defrosted food may Defrosting only be re-frozen after it has been cooked.
Freezing and storing food Freezer tray Cool pack The freezer tray is useful for freezing The cool pack prevents the small items such as berries and temperature in the freezer rising too vegetables. They can be frozen quickly in the event of a power cut. individually and therefore maintain their Place the cool pack in the upper shape when defrosted.
Defrosting This freezer is equipped with a Frost free system. The freezer defrosts automatically. The moisture generated by defrosting settles on the condensor and is automatically dissipated from time to time. This automatic defrosting system enables the freezer to remain permanently ice-free, however, the food stored in the freezer will not defrost.
Cleaning and care Cleaning the interior and Never use cleaning agents accessories containing abrasive substances Use warm water with a little washing-up such as sand, soda, acids, chlorides liquid. Wash all accessories and or chemical solvents. drawers by hand only. Do not wash in a "Non-abrasive"...
Cleaning and care After cleaning ^ Close the door and switch the appliance on. ^ Switch on the Super freeze function so that the freezer can cool down quickly. The indicator light will come on. ^ Put the glass cold plates back in the appliance.
If it has, contact the Miele Service Department. ^ Check that the door has been closed properly.
Page 28
Problem solving guide . . . food has frozen together.."nA" appears in the temperature display. Use a blunt instrument, e.g. a spoon handle or plastic scraper, to prise it The temperature has risen too high at apart carefully.
Page 29
If you still cannot remedy the fault having followed these suggestions, please contact the Miele Service Department. To prevent unnecessary loss of temperature it is advisable not to open the door while waiting for the...
Noises Normal noises What causes them Humming noise made by the motor (compressor). This noise can Brrrrr... get louder for brief periods when the motor is switching on. Blubb, blubb..A gurgling noise can be heard when coolant is circulating through the pipes.
– your Miele Dealer – Miele (see back cover for contact details). When contacting your Dealer or Miele, please quote the model and serial number of your appliance. This information is given on the data plate inside your appliance.
Electrical connection Electrical connection U.K. Non-rewireable plugs (BS 1363) All electrical work should be carried out The fuse cover must be re-fitted when by a suitably qualified and competent changing the fuse, and if the fuse cover person in strict accordance with current is lost, the plug must not be used until a local and national safety (BS 7671 in suitable replacement is obtained.
Should you require further assistance please The air inlet and outlet must not be contact your Miele customer service covered or blocked in any way. centre. They should be dusted on a regular basis.
All the necessary parts are supplied or ^ On no account should the spacers can be ordered from the Miele Spare be removed from the back of the Parts Department. appliance. These ensure the gap...
Adjusting the door hinges The door hinges are set ex-works to – If you would like the appliance door enable the door to be opened wide. to be cushioned so that it opens more softly, the spring tension on the However, if the opening angle of the appliance door can be adjusted.
Changing the door hinging ^ Slide the door outwards and lift it off Before building the appliance in, you will need to decide on which side the door is to be hinged. If left hand door ^ Unscrew the fixing screws d hinging is required, follow the completely, and loosely screw them instructions below.
Page 38
Changing the door hinging ^ Unscrew mounting b and pull ^ Replace the hinges in their diagonally soft-close mechanism c downwards opposite corners b. to remove it. ^ Use a powered screwdriver to secure ^ Undo ball joint d using a spanner the hinges;...
Page 39
Changing the door hinging ^ Push the appliance door onto the pre-fitted screws, and then tighten the screws. ^ Replace covers a, b and c. ^ Replace the locking pins into the top of the hinges to prevent the doors opening too far.
Maximum weight of Appliance furniture door in kg The housing unit must be carefully FN 9752 i aligned using a spirit level before installing the appliance. The unit corners must be at right angles, as otherwise the furniture door will not align correctly with the 4 corners of the appliance.
Page 41
Building in the appliance Preparing the appliance ^ Open the appliance door. ^ Slide cover strip a into the holder in the middle of the appliance as illustrated with the bumps facing downwards. The bumps will fit into the keyhole slots. ^ Using a screwdriver, remove cover ^ Position the mains electricity cable so c from the top corner of the...
Page 42
Building in the appliance Building in the appliance ^ Fit cover g onto fixing bracket h. ^ Secure fixing bracket h to the bottom of the appliance with screws i (M5 x 15). ^ Carefully remove the protective foil from sealing strip j. –...
Building in the appliance Securing the appliance in the On furniture with door fittings (e.g. stubs, seals etc) the dimension of niche these must be taken into account when making sure there is a gap all round of 42 mm. ^ Pull the appliance forwards by the dimension of the door fitting to keep the gap at 42 mm all round.
Building in the appliance ^ Break off the protruding end of bottom cover e. It is no longer required. ^ Fit angled cover g onto bottom fixing bracket c. ^ Close the appliance door. Fitting a furniture door ^ Loosen screws b on the top and bottom fixing brackets c.
Page 45
Building in the appliance ^ Using a pencil, lightly mark a line ^ Hang the furniture door onto adjusting bolts h. down the centre of the inside of the furniture door. ^ Loosely attach nuts c on the ^ Hang fixing bracket d with the fitting adjusting bolts.
Page 46
Building in the appliance Securing the appliance door to the furniture door: ^ Close the door and align it with ^ Screw fixing bracket a into the neighbouring furniture doors. pre-drilled holes in the appliance ^ Whilst counterholding the adjusting door using hexagonal screw b.
Page 47
Building in the appliance ^ Replace all the covers. To make sure the appliance is correctly fitted: – The door must close properly. – The door must not touch the furniture carcase. – The seal at the top edge of the handle side must fit properly.