Table of Contents
Advertisement
Operation Mode Behavior
Ethernet Information
1.
Press 5 from the System Information Menu for Ethernet Information.
AlarmNet Info
1.
Press 6 from the System Information Menu for AlarmNet Info Cell Strength: 0 to 100% Status: Registered/Not Registered.
AlarmNet Temp Pin
2.
Press 7 from the System Information Menu for AlarmNet Temp Pin. Use this PIN if the fire alarm control panel is replaced on the
CCP.
8.5 Operation Mode Behavior
The control panel can display one or more of the following seven conditions at any given moment:
•
Normal
Table 8.4 describes the behavior of the panel in each of these modes.
When you look at the LCD, the screen will display FIRE for the "Fire System", CO for the "CO System". The highest priority event
will display first and include the Event Count (see Figure 8.5).
Press the <Down> arrow to view the location and type of alarm, supervisory or trouble. If you programmed the panel to Auto Display
Event, information describing the highest priority active event will display on the first two lines. The 3 and 4th line will show the status
of which Event Types are active for each system (fire and CO). Auto Display Event activates after two minutes of annunciator inactivity.
GWF-7075 Addressable Fire Alarm Control Panel Manual — P/N LS10147-002GF-E:E 06/11/2019
Figure 8.4 Ethernet Information
•
Alarm
•
Prealarm
Figure 8.5 Highest Priority Event Display
Figure 8.5 This Screen displays when more than 3 Event Types are active.
•
Supervisory •
Trouble
System Operation
•
Silenced
•
Reset
65
Advertisement
Table of Contents
