Table of Contents
Advertisement
System Operation
8.6 Operation Mode Behavior Conditions
The control panel can be in one of the following seven conditions at any given moment:
•
Normal
Table 8.4 describes the behavior of the panel in each of these modes.
Operation
Mode
No alarm, Supervisories or
trouble condition exists and
Normal
menus are not in use.
A smoke detector goes into
alarm or a pull station is
activated.
CO detector goes into alarm.
Alarm
If more than 3 categories are
active at a single time screen will
display as shown.
66
•
Alarm
•
Pre-alarm
Operation Mode
Condition
SYSTEM POWER LED is on.
The All Systems Normal display indicates that
the system is in normal mode. The current date
and time display on the last line of the LCD.
The communicator seizes control of the phone
line and calls the central station.
The on-board annunciator sounds a loud,
steady beep (any notification devices attached
to the system will also sound).
GENERAL ALARM LED flashes.
The LCD displays a screen similar to this one.
Table 8.4 : Operation Mode Behavior
GWF-7075 Addressable Fire Alarm Control Panel Manual — P/N LS10147-002GF-E:E 06/11/2019
•
Supervisory •
Trouble
System Behavior
Operation Mode Behavior Conditions
•
Silenced
•
Operation Mode Troubleshooting
Options
Enter the appropriate code, or rotate the key to
activate the Main Menu.
Press the down arrow to view the alarm. A
screen similar to this one displays.
Press SILENCE and enter an access code (or
activate the key) to silence the annunciator (and
any notification devices attached to the system).
When the alarm condition clears, press RESET
and enter a code (or activate the key) to restore
the panel to normal.
Reset
Advertisement
Table of Contents
