Table of Contents
Advertisement
Trouble shooting 72
Error Contents :
Software Error
Details :
Condition of occurrence : Micon program performed an abnormal control.
Release condition : Micon has been reset, and the control of Network Convertor became normal.
Cause 1 : External noise
p Check continuation of error.
(1) If error is released automatically, it is not a defect of PCB. Remove the surrounding noise source around Network Convertor.
(2) If error is not released automatically, check followings.
OK
pAfter pressing SW104 of Network Convertor PCB for 5 seconds or turning on power.
Does error code display reappear?
YES
Remove the surrounding noise source.
OK
Cause 2 : Network Convertor is defective.
Replace Network Convertor.
Symptom :
Error Code display [ 21 ]
All the control items do not operate.
NO
It is not a defect of PCB. Remove the surrounding noise source.
06-73
Advertisement
Table of Contents
Troubleshooting
